Teledyne 7000 Series Operating and maintenance manual

INSTALLATION PROCEDURE FOR 7000
SERIES BATTERIES WITH TERMINAL
CONNECTIONS
Document No.
TD14-7-03
Revision
NC
Date
11/3/11
Page
1 of 3
INSTALLATION PROCEDURE FOR
7000 SERIES BATTERIES
WITH TERMINAL CONNECTIONS
Prepared by J. M. Rajpara
Date:
11/3/11

A. INSTALLATION PROCEDURE FOR 7600 BATTERY WITH TERMINAL CONNECTIONS
This installation procedure is for a typical 7600 battery with terminal connections. For detail
Instructions see the Aircraft Maintenance Manual or STC
1. Ensure that the battery and external power switches, in the cockpit, are in the off
position.
2. Open battery compartment access panels.
3. Position the battery in the battery tray and secure with hold down bolts. Tighten wing
nuts to a torque of 10 in. lbs. See Figure 1 for Battery Installation drawing.
4. Connect the positive and negative cables from the aircraft to the positive and negative
terminals on the battery.
5. Secure the battery compartment.
NOTE:
For Instructions for Continued Airworthiness of the battery see
TELEDYNE BATTERY PRODUCTS’ ICA AND COMPONENT MAINTENANCE
MAUNUAL FOR TSO-C173 APPROVED GILL 7000 SERIES LT VRLA AIRCRAFT
BATTERIES, DOCUMENT NO. TD14-8-01. This document is available on
TELEDYNE BATTERY PRODUCTS website: www.gillbattery.com
TELEDYNE BATTERY PRODUCTS
840 West Brockton Avenue, Redlands, CA 92374
Document Number
Page
Rev
TD14-7-03 2 of 3 NC

Figure 1: BATTERY WITH TERMINAL CONNECTIONS INSTALLATION
TELEDYNE BATTERY PRODUCTS
840 West Brockton Avenue, Redlands, CA 92374
Document Number
Page
Rev
TD14-7-03 3 of 3 NC