Teledyne 7000 Series Operating and maintenance manual

INSTALLATION PROCEDURE FOR 7000
SERIES BATTERIES
Document No.
TD14-7-01
Revision
NC
Date
8/25/10
Page
1 of 3
INSTALLATION PROCEDURE FOR
7000 SERIES BATTERIES
TELEDYNE BATTERY PRODUCTS
840 WEST BROCKTON AVENUE
REDLANDS, CA 92374
Prepared by J. M. Rajpara
Date:
8/25/10

A. INSTALLATION PROCEDURE FOR 7600 BATTERY
This installation procedure is for a typical 7600 battery installation. For detail
Instructions see the Aircraft Maintenance Manual or STC
1. Ensure that the battery and external power switches, in the cockpit, are in the off
position.
2. Open battery compartment access panels.
3. Position the battery in the battery tray and secure with hold down bolts. Tighten wing
nuts to a torque of 10 in. lbs. See Figure 1 for Battery Installation drawing.
4. Connect vent tubes and tighten clamps (if required).
NOTE: If battery is installed in a ventilated battery compartment the vent tubes are not
required.
5. Connect battery connector to battery. Check that the positive and negative cable from
the aircraft, are connected to the correct polarity on the aircraft connector before
connecting to the battery.
6. Secure the battery compartment.
NOTE:
For Instructions for Continued Airworthiness of the battery see
TELEDYNE BATTERY PRODUCTS’ ICA AND COMPONENT MAINTENANCE
MAUNUAL FOR TSO-C173 APPROVED GILL 7000 SERIES LT VRLA AIRCRAFT
BATTERIES, DOCUMENT NO. TD14-8-01. This document is available on
TELEDYNE BATTERY PRODUCTS website: www.gillbattery.com
TELEDYNE BATTERY PRODUCTS
840 West Brockton Avenue, Redlands, CA 92374
Document Number
Page
Rev
TD14-7-01 2 of 3 NC

Figure 1: BATTERY INSTALLATION
TELEDYNE BATTERY PRODUCTS
840 West Brockton Avenue, Redlands, CA 92374
Document Number
Page
Rev
TD14-7-01 3 of 3 NC