Telex ALP-600 User manual

INSTRUCTION MANUAL
General Description
The ALP-600 Antenna Bracket Kit is a
configuration of aluminum brackets with
mounting hardware used to securely hold the
ALP-600 Telescoping Antenna Mast.
The Universal Stadium Mounting Plate, (Figure 1)
can be mounted vertically or horizontally
depending upon the object in which it is mounted
to. The Antenna Mast Bracket Assembly, (Figure
2) then easily attaches to the previously mounted
plate by turning the hand knobs until tight.
Components
.Universal Stadium Antenna Mounting Plate
.Antenna Mast Bracket Assembly
.Antenna Bracket Hardware Kit
.2 - U-bolts 4 - Hex Nuts
.4 - Flat and Lock washers 2 - Lag Screws
.4 - Wing Nuts
-1-
ALP-600
ANTENNA BRACKET KIT
Order No. 878898 PN 801546
8601 East Cornhusker Highway, Lincoln, NE 68505
TELEX COMMUNICATIONS, INC.
Figure 1
Universal Stadium Mounting Plate Figure 2
Antenna Mast Bracket Assembly

Antenna Mast Bracket Assembly
Assembly
Insert hand knob with 3/8" flat washer into
antenna mast bracket assembly, see Figure 3.
Insert retaining ring into groove on hand knob under
loop strap on antenna mast bracket, see Figure 4.
Repeat following step for remaining hand knob.
-2-
BRACKET
HANDKNOB RETAININGRING
WASHER
FINALASSEMBLY
Figure 3 Figure 4 Figure 5

Universal Stadium Mounting Plate and
Antenna Mast Bracket Assembly
-3-
CENTERLINE
MOUNTING
HOLES
CENTERLINE
MOUNTING
HOLES
MOUNTING
HOLES MOUNTING
HOLES
Vertical
Mounting Horizontal
Mounting
Figure 6
Mounting Holes
Hole alignment will be off center to right side. Hole alignment will be off center to left side.
U-clamps or lag screws may be used
for permanent mounting

PRINTED IN U.S.A..
Copyright© 1997 by Telex
TELEX COMMUNICATIONS, INC.
All rights reserved
July 1997 -4-
Figure 7
Mounting Suggestions
Vertical Horizontal
Table