Telex Audiocom SS-1002 Manual

SS1002 / SS2002 Supplemental Information 1
9330-7627-000 Rev B 05/2005
Audiocom®
SS1002 / SS2002 Supplemental Information
Installing the Box to the Faceplate
General Instructions
If you ordered SS1002/ SS2002 boxes and faceplates separately, use
these instructions to assemble the speaker stations. Once you have
assembled the stations, refer to the User Manual for all installation and
operation information.
Step 1: Connecting the Wires from the Box to the Faceplate
Use the appropriate pin connections, below, to connect the wires from the XLR audio connector on the box to
the terminal strip on the circuit board. (Or in the case of the “U” box, connect wires from the intercom system to
the terminal strip.) To insert a wire into the terminal strip, push back the green lever on the top of the terminal as
shown, then insert the wire and release the lever.
XLR Connector
on Box
Terminal Strip on
Circuit Board
Description
Pin 1 TB1-1 DC Common
Pin 2 TB1-3 Audiocom Channel audio low and +24VDC phan-
tom power
Pin 3 TB1-4 Audiocom Channel audio high and +24VDC
phantom power
Table 1: SS1002 wire connections for use in Audiocom System
XLR Connector
on Box
Terminal Strip on
Circuit Board
Description
Pin 1 TB1-1 Common
Pin 2 TB1-3 Clear-com power input
Pin 3 TB1-4 Clear-com audio / call signal
Table 2: SS1002 wire connections for use in Clear-com System

2SS1002 / SS2002 Supplemental Information
*When connected as shown, Clear-com Line A corresponds to SS2002 Ch 1 and Clear-com Line B corresponds to
SS2002 Ch 2.
Step 2: Assemble the Faceplate to the Box
Use the four screws supplied with the faceplate.
Step 3: Install the Intercom Station
Refer to the User Instructions for further information.
XLR Connector on
Box
Terminal Strip on
Circuit Board
Description
Pin 1 TB1-1 Common
Pin 2 No connection
Pin 3 TB1-3 Audiocom Channel 1 audio low and +24VDC
phantom power
Pin 4 TB1-4 Audiocom Channel 1 audio high and +24VDC
phantom power
Pin 5 TB1-5 Audiocom Channel 2 audio low and +24VDC
phantom power
Pin 6 TB1-6 Audiocom Channel 2 audio high and +24VDC
phantom power
Table 3: SS2002 wire connections for use in Audiocom System
XLR Connector on
Box
Terminal Strip on
Circuit Board
Description
Pin 1 TB1-1 Common
Pin 2 TB1-3 Clear-com power input
Pin 3 TB1-6 Clear-com Line B*
Pin 4 TB1-4 Clear-com Line A*
Pin 5 No Connection
Pin 6 No Connection
Table 4: SS2000 wire connections for use in Clear-com System