tell easyTEMP User manual

easyTEMP temperature sensor
for Pager7 and Pager8 devices
Installation guide
Document version: 1.018.03.2020
Technical specification:
Temperature measuring range: -30ºC…+70ºC
Operating temperature: -30ºC…+70ºC
Measuring accuracy: +/-1ºC
Supply voltage: 12…30V DC
Current consumption: <1mA @ 12V DC
Cable length: 1m
Dimensions: 61 x 12mm + strain relief
Output signal: serial data communication
Wiring:
White: +12/24V DC
Brown: 0V (GND)
Green: Signal wire (output)
Yellow: Signal wire (input)
Fasten the sensor and the cable properly to avoid damaging the unit.

2
Wiring guide for Pager7 devices:
For the Pager 7, you can connect one
easyTEMP temperature sensor per input,
i.e. each sensor should be connected to
a different input, as shown in the figure
on the left.
The Yellow wire of the sensor is not used
when using the sensor with a Pager7
device.
Information about the settings are
available in the Pager7 User guide.
Wiring guide for Pager8 devices:
The Pager8 device supports
easyTEMP temperature sensors
through its RX serial port input.
If you want to use more than one
sensor, connect the Green wire of
the first sensor to the RX input of the
Pager8 device, and then connect
the Yellow wire of each sensor to
the Green wire of the next sensor in
line (serial connection), as shown in
the figure on the left . The Yellow
wire of the last sensor should not be
connected.
Information about the settings are
available in the Pager8 User guide.