Tellus Power TP5-30-480 User manual
TELLUS POWER GREEN
DC FAST CHARGER
30kW Wall Mount
DC Fast Charging Station
TELLUS POWER GREEN
DC FAST CHARGER
Specifications
Tellus Power Green
23541 Ridge Route Drive Suite B
Laguna Hills, CA 92653
United States www.telluspowergreen.com
Product # TP5-30-480
Input 480VAC (3P+N+PE)
Frequency 60Hz
Output Voltage 150 to 1000VDC
Output Current 0 to 100A
Connector(s) CCS1 or CHAdeMO
Efficiency ≥94% at nominal output power
Power Factor > 0.98
Operating Temperature 22°F to 131°F (-30°C to 55°C)
Working || Storage humidity ≤ 95% RH || ≤ 99% RH (Non-condensing)
Altitude < 6600ft (2000m)
Display 7’’ LCD with touch screen
RFID system ISO || IEC 14443A/B
Dimensions (l x d x h) 21’’ x 12’’ x 27’’
Protective Class NEMA 3S, IK 10
Cooling System Air cooled
Weight 176 lbs (80kg)
Charging Protocol Mode 4, IEC-61851, ISO-15118, DIN SPEC 70121
Mode 4, CHAdeMO 0.9, 1.0
Length of charging cable 16ft (5m)
Interface protocol OCPP 1.6J
Communication Ethernet / 4G Wi-Fi
Electrical Safety: GFCI RCD 20 mA Type A (UL)
Electrical Safety: Surge Protection 20 kA
Electrical Safety General Over Voltage, Under Voltage, Over Current, Missing Ground
Electrical Safety: Output Short Output power disabled when output is short circuited
Electrical Safety Temperature Temperature Sensors @ Charge Coupler and Power
Electronics
Emergency Stop Emergency Stop Button Disables Output Power
Regulatory Compliance UL-2202 || EMC: EN 61000-6-1:2007, EN 61000-6-
3:2007/A1:2011/AC:2012
2
30kW DC Fast Charger Pedestal Dimensions
Below is the 2D representation of the 30kW Pedestal Unit. The height of the pedestal and the distance between each screw
hole on the mounting plate along is detailed. All the dimensions are in inches.
Provision to draw
the Input cable from
the base
Base of the Pedestal
Mounting
Bracket
Provision
for the
Holster
3
Installing Pedestal to Base
It is recommended that the pedestal is installed on a concrete floor or pad. Please note the dimensions of the base prior to
installing. It is a perfect square, so it is symmetrical on all sides. Install using the anchors screws. These anchors will be
provided along with the pedestal unit (Units are in inches)
The input cable for the charging station should be routed through the base of the pedestal and will be drawn out through the
hole provisioned on the front side the pedestal unit.
4
Mounting Charger to Pedestal
Install charger as shown in the figures below using the screw sizes provided below (not included).
•3/8”-16x1 Hex Screw
•3/8”-16 Hex Nut
•3/8” Split Washer
•3/8” Flat Washer
5
Mounting Charger Holster to Pedestal
Remove access panel on the left side of the charger. Locate the holes that will secure the holster. Now align holster with
holes and fasten down using the screw sizes provided below (not included).
•Bolt
•Nut
•Washer
Left Side
Right Side
