Teltonika FM6 Safety guide

FM6
FMB6
Professional tracker
How to connect
FMB6 to Carrier
freezers

1
Main installation location is displayed in the picture below:
Figure 1 Panel cover

2
Remove the panel stickers marked in the picture:
Figure 2 Fuse panel stickers location

3
Unscrew the panel screws marked in the picture and open the panel cover:
Figure 3 Location of the screws

4
The picture below displays the location of the electric panel where connectors can be found:
Figure 4 The main connector location

5
All of the the connectors displayed in screenshot, find the marked connector:
Figure 5 The main connector location

6
The connector should have a cap attached as displayed in the close up screenshot, unclip the cap.
Figure 6 The main connector cap

7
The FMB6 devices can be installed in the panel as displayed in this example:
Figure 7 An example of FMB6 device installed in the panel

8
Device’s wires lead down through gasket to the connector as displayed below:
Figure 8 An example of FMB6 device installed in the panel full view

9
Connect the FMB6 wires to the main connector in the electric panel exactly as shown below. Wires marked
in the screenshot (RS232 GND(Black), RS232 TX (Orange/Blue), RS232 RX(Yellow/Green)).
Figure 9 The connection of the FMB6 device‘s wires to the main connector