Teltonika MH2000 Manual

Handheld GPS/GSM Tracker
Version 1.04
Release date: 2010 07 02
MH2000
Q ick Start USER MANUAL

Handheld GPS/GSM Tracker
Version 1.04
Release date: 2010 07 02
WELCOME!
Thank yo for p rchasing o r device! We hope it will satisfy yo r
expectations and yo will enjoy its partic lar feat res. Please, find
several min tes to read this doc ment before beginning to work with
MH2000.
All rights protected. © 2009 Ltd Teltonika.
All rights are owned by the a thor. Yo may not copy, compile or
transfer the present information to third parties or distrib te it witho t
a prior written consent by UAB Teltonika.
Other prod cts and company names mentioned in this Man al may be
trademarks or names of prod cts of s ch companies.
In case yo have problems with the se of the prod ct beyond yo r
possibilities to solve it, please address them to the Technical Assistance
Center (TAC) by e-Mail s [email protected] or contact yo r local seller.
We wo ld be pleased to be of any assistance to yo .
Teltonika recommends to read User Man al caref lly. Teltonika does
not take any responsibility for problems that occ r d e to an
npropriate sage of a device, incorrect config ration or sage of
software that was iss ed by a third party. Teltonika reserves a right to
modify the f nctionality of the device witho t any prior notice.

Handheld GPS/GSM Tracker
Version 1.04
Release date: 2010 07 02
1 x MH2000 Handheld Tracker
1 x Mini screwdriver
1 x Battery
1 x Neck strap
1 x Q ick start User Man al
1 x 230V Charger
NOTE: The man fact rer's set does not incl de any SIM card which is
necessary to connect to the GSM network. SIM card can be acq ired
from yo r local s pplier of GSM services.
If an ns itable SIM card has been inserted or the device fails to detect
it, the device will reload a tomatically and tries to start the connection
anew (if SIM card is not inserted the device will reloads three times). If
the reconnection fails, the device will show it by its indicator. If the card
has been inserted later, the device m st be switched off and switched
on again.
STANDARD PACKAGE CONTENT
1
LED INDICATION
2
Device sleeps or switched off
Device fo nd its location
GSM error (check PIN/SIM/Operator)
Device registering to GSM network
Reached the critical battery charge level
Device searching its location
Panic mode is activated

Handheld GPS/GSM Tracker
Version 1.04
Release date: 2010 07 02
INSERTING SIM CARD
Open the back cover and find the SIM card holder. Pay atention how the
SIM card sho ld be placed into the device. It is shown by the symbol on
the device.
BATTERY CHARGING
The device battery can be charged sing BL-5C battery charger only. P t
the battery into the charger and pl g it into the wall o tlet. When the
charge process starts and finishes it will be indicated by LED located on
the charger.
After the battery is f lly charged insert it into the device and t rn the
device on. The batteries always are provided half charged. Charge the
battery before yo start to se the device.
CONNECTING TO PC
The device can be connected to a PC only sing a special cable. This
cable has a special integrated chip which allows comm nication
between the device and PC.
NOTE: Connecting the cable which is not provided by company Teltonika
yo will fall in the risk to damage the device.
Insertin
g SIM
card
position
Place of
SIM card
NOTE: If the red GSM LED
is blinking check if the SIM
card is placed correctly, or
the PIN code is removed.
DEVICE PREPARATION
3

Handheld GPS/GSM Tracker
Version 1.04
Release date: 2010 07 02
1 – LED indicators
2 – Panic B tton
3 – T rn ON/OFF B tton
4 – Micro USB
LED INDICATORS
LED indicators indicate the stat s
that the device is in at the time.
PANIC BUTTON
Press the b tton and hold it
pressed ntil all LEDs lights p,
then release the b tton and
device will activates the panic
mode.
TURN ON/OFF BUTTON
To turn on the device press the
b tton shortly and release it. To
turn off the device press and hold
b tton pressed ntil all LEDs
Lights p then release it.
CONNECTOR
(Additional accessory is needed)
This connector can be sed for a device firmware pdate and
deb g log translation to PC only.
BATTERY CHARGING
(Additional accessory is needed)
Battery can be charged sing the special external BL-5C battery
charger. Take o t the battery from the device fit it into the
charger and pl g the charger to the o tlet (230V).
1
2
3
4
GETTING TO KNOW THE DEVICE
4

Handheld GPS/GSM Tracker
Version 1.04
Release date: 2010 07 02
DEVICE CONFIGURATION THROUGH THE SMS
5
SMS TEXT THE MEANING
CFG_AD_CELL+GPS
AD Alarm Data -This message will
config res the device to collect all available
data in the memory while in panic mode.
CFG_AD_CELL AD Alarm Data – Collect data with GSM
base station information only.
CFG_AD_GPS AD Alarm Data - Collect data with GPS
coordinates only.
CFG_ADT_<time in sec.>
i.e. CFG_ADT_180
AD Alarm Duration Time – Set p the
time how long the device will work in panic
mode when it is activated.
CFG_ADP_<phone n mber>
i.e. CFG_ADP_+37066612345
ADP- Alarm Destination Number – set p
the phone n mber to which the device
sho ld send information when panic mode
is activated.
CFG_ADSP_<time in sec.>
i.e. CFG_ADSP_60
ADSP Alarm Data Sending Period – set p
how often the device sho ld send SMS
messages to the set n mber. Minimal
available period is 30sec.
CFG_CLP_<mode>
i.e. CFG_CLP_24
i.e. CFG_CLP_1
i.e. CFG_CLP_0
CLP Coordinates Logging Period – set p
in what mode device will work, this mode
determined how often device will collect its
position in the memory. Modes:
24coordinates/day and 1 coordinate/day or
to switch off logging at all.
CFG_PLD_CELL+GPS
PLD Periodical Logging Data – This
message will config re all available data in
the memory while in normal mode
CFG_PLD_CELL PLD Periodical Logging Data - Collect data
with GSM base station information only.
CFG_PLD_GPS PLD Periodical Logging Data - Collect data

Handheld GPS/GSM Tracker
Version 1.04
Release date: 2010 07 02
with GPS coordinates only.
CFG_DTZ_<Time zone>
i.e. CFG_DTZ_+3
DTZ Device Time Zone – set p the time
zone if yo want to get yo r c rrent
location time in SMS.
CFG_CBN_<Battery level
%>_<Phone n mber>
i.e.
CFG_CBN_30_+37066612345
CBN Charge Battery Notification – Set p
the level of the battery when device sho ld
send notification to set n mber abo t
battery level.
CFG_24H_SEND_<mode>
i.e. CFG_24H_SEND_0
i.e. CFG_24H_SEND_1
24H_SEND Device coordinates sending
mode – select if device will send periodical
coordinates after collecting 24 coordinates
a tomatically (1) or not (0).
SMS text is not case sensitive, capital and small letters works as well.
SMS TEXT THE MEANING
FIX? Ret rn the location where the device is
at the moment.
INF? Ret rn all available information abo t
device c rrent stat s.
LOG?1
Collect all 24 data packets from the
memory and send them to the
req ested n mber.
CFG? Ret rn all available config ration
parameters of the device
DEFAULT Restores all parameters to factory
1 Device will send data in PDU format. To nderstand this format additional
software is needed.
REQUESTS
6

Handheld GPS/GSM Tracker
Version 1.04
Release date: 2010 07 02
defa lt.
ALARM_OFF T rns off the panic mode if it is
activated.
WIM? Creates and ret rn the link of position
to the google map.
Device will inform abo t s ccessf lly changed parameter in all
config ration SMS messages if the SMS message yo have sent will be
correct. Overwise it will ignore yo r req est.
PARAMETER VALUE AND DESCRIPTION
Time: Set time (if there was no fix, defa lt
time is 2007.01.01 00:00:00)
Device_name: Given name to the device. Defa lt is
MH2000
ADT:
Alarm d ration time. Time how long the
device works in alarm mode (shown in
seconds) Defa lt: 300sec. Minimal
available d ration time is 30sec.
AD:
Alarm data: Data type, which is sent to
set n mber in panic mode (02 - GSM
base staion information only, 03 - GPS
coordinates only, 04 - all available
data). Defa lt is 04.
ADP:
Alarm destination n mber. N mber, to
which data will be sent in panic mode.
Defa lt is empty.
ADSP: Alarm data sending period. How often
data will be sent to the set n mber.
FACTORY DEFAULTS
7

Handheld GPS/GSM Tracker
Version 1.04
Release date: 2010 07 02
Shown in seconds. Defa lt is 60.
PLD: The same as in AD parameter
CLP:
Coordinates logging period. How often
the device will save its position in the
memory. Shown in seconds. Defa lt is
3600 sec.
24H_SEND : Defa lt val e is not (0).
DTZ: Device time zone. Set time zone of the
device. Defa lt is 0.0
CBN:
Charge battery notification. Battery
level, when reached sends notification
to set n mber. Shown level is in %.
Defa lt 5, (no n mber)
MODE LIFE TIME
24coordinates/day 150 h2
1coordinate/day 400 h2
Sleep 450 h2
2 Declared battery life time is aproximate and may change depending on GSM
signal level, GPS signal availability and operating temperat re.
BATTERY LIFE TIME
8

Handheld GPS/GSM Tracker
Version 1.04
Release date: 2010 07 02
Recommended operating
temperat re 0 p to 50ºC
Storage temperat re -20 p to 60 ºC
This device is a high-q ality design prod ct; therefore, it sho ld be
handled caref lly. The following advice will assist yo in meeting the
g arantee req irements.
Do not let the device get wet. In the precipitation, h midity and all sorts
of liq ids there may be minerals which may be a ca se of corrosion of
the electricity chains. If yo r device got wet, take o t the battery and let
the device get f lly dry; afterwards, insert the battery again.
Do not se or keep the device in d sty and dirty places. Its moving and
electronic parts may be damaged.
Do not keep the device in high temperat res. High temperat re may
red ce the life time of the electronic parts or damage the batteries and
deform or melt some plastic parts.
Do not keep the device in cold environment. If the device warms p to
the room temperat re, h midity may start condensing which may ca se
the fail re of electricity circ it boards.
Do not try opening the device except as specified in this Q ick starat
User Man al.
RECOMMENDATIONS
9
MAINTENANCE AND REPAIR
10