Teltonika RUT200 User manual

Quick Start Guide v1.1
Wiki knowledge base
RUT200
https://wiki.teltonika-networks.com/

FRONT VIEW
BACK VIEW
WiFi antenna connector Mobile AUX antenna
connector Mobile MAIN antenna connector
Reset button
Mobile signal strength indication LEDs
Ethernet
ports
LAN LEDSIM holder
Power socket
Power LED
WAN LED
Mobile network type LEDs
(transparent view 2G, 3G, 4G)

Ground / Black wire
Output / White wire
Power / Red wire
Input / Green wire
POWER SOCKET PINOUT
1. Push the SIM holder button with the SIM needle.
2. Pull out the SIM holder.
3. Insert your SIM card* into the SIM holder.
4. Slide the SIM holder back into the router.
5. Attach all antennas.
6. Connect the power adapter to the socket on the front of the device. Then plug the other end of the power
adapter into a power outlet.
7. Connect to the device wirelessly using SSID and password provided on the device information label or use an
Ethernet cable connected to LAN port.
*If device is used in damp/high vibration environments, it is strongly recommended to apply a thin layer of anti-corrosive agent over SIM card
contacts. Make sure the agent is suitable for electronic contacts.
HARDWARE INSTALLATION

LOGIN TO DEVICE
TECHNICAL INFORMATION
Radio specifications
Bundled accessories specifications**
RF technologies
Max RF power
2G, 3G, 4G, WiFi
33 dBm@GSM, 24 dBm@WCDMA, 23 dBm@LTE, 20 dBm@ WiFi
Mobile antenna 698~960 / 1710~2690 MHz, 50 Ω, VSWR<3, gain*** 4 dBi, omnidirectional, SMA male connector
Power adapter Input: 0.45 A@100-240 VAC, Output: 9 VDC, 1A, 4-pin plug
WiFi antenna 2400~2500 MHz, 50 Ω, VSWR<2.5, gain*** 5 dBi, omnidirectional, RP-SMA male connector
1. To enter the router's Web interface (WebUI), type http://192.168.1.1 into the URL field of your Internet browser*.
2.Use login information shown in image A when prompted for authentication.
3. After you login, you will be prompted to change your password for security reasons. The new password must
contain at least 8 characters, including at least one uppercase letter, one lowercase letter and one digit. This step is
mandatory and you will not be able to interact with the router's WebUI before you change the password.
4. When you change the router's password, the Configuration Wizard will start. The Configuration Wizard is a tool
used to setup some of the router's main operating parameters.
5. Go to the Overview page and pay attention to the Signal Strength indication (image B). To maximize the
cellular performance try adjusting the antennas or changing the location of your device to achieve the best signal
conditions.
*To ensure maximum compatibility please use following latest internet browsing applications: Chrome, Firefox, Edge, Opera, Safari, Android Chrome, Android Firefox.
**Order code dependent.
***Higher gain antenna can be connected to compensate for cable attenuation when a cable is used. The user is responsible for the compliance with the legal regulations.
www.teltonika-networks.com 2022 Teltonika Networks