Teltonika RUT230 User manual

1
USER MANUAL
RUT230 3G Router

2
Legal notice
all rights reserved. Reproduction, transfer, distribution or storage
of part or all of the contents in this document in any form without the prior written permission of
TELTONIKA Ltd is prohibited. The manufacturer reserves the right to modify the product and manual
for the purpose of technical improvement without prior notice.
Other product and company names mentioned herein may be trademarks or trade names of
their respective owners.
Attention
Before using the device we strongly recommend reading this user manual first.
Do not rip open the device. Do not touch the device if the device block is broken.
All wireless devices for data transferring may be susceptible to interference,
which could affect performance.
The device is not water-resistant. Keep it dry.
Device is powered by low voltage +9V DC power adapter.

3
Safety information
The RUT230 router must be used in compliance with any and all applicable national and international
laws and with any special restrictions regulating the utilization of the communication module in
prescribed applications and environments.
You have to be familiar with the safety requirements before using the device!
Specifications
Software
RUT230_R_XX.XX.XXX
Frequency bands*
EEE802,11b/g/n 2400 MHz, GSM/EDGE/3G, UMTS/HSPA+
Max. RF power
20 dBm@WiFi, 33 dBm@GSM/GPRS/EDGE, 24 dBm@UMTS
Representative accessories specifications
Power
AC/DC power adapter 9 V 1 A, 4 pin plug
GSM/UMTS antenna
830-960/1710-2170       gain** 1 dBi, omnidirectional,
SMA male connector
WiFi antenna
2401-2462    , omnidirectional, RP-SMA
connector
* Supported frequency bands are dependent on geographical location and may not be available in all markets.
** If an extension cable is used to attach the antenna, the antenna gain may be higher by the amount of cable
attenuation. The user is responsible for the compliance with the legal regulations.

4
To avoid burning and voltage caused traumas, of the personnel working with the device, please
follow these safety requirements:
The device is intended for supply from a Limited Power Source (LPS) that power
consumption should not exceed 15VA and current rating of over current protective
device should not exceed 2A.
The highest transient over voltage in the output (secondary circuit) of used PSU shall
not exceed 36V peak.
The device can be used with the Personal Computer (first safety class) or Notebook
(second safety class). Associated equipment: PSU (power supply unit) (LPS) and
personal computer (PC) shall comply with the requirements of standard EN 60950-1.
Do not mount or service the device during a thunderstorm.
To avoid mechanical damages to the device it is recommended to transport it packed
in a damage-proof pack.
Protection in primary circuits of associated PC and PSU (LPS) against short circuits
and earth faults of associated PC shall be provided as part of the building
installation.
To avoid mechanical damage to the device it is recommended to transport it packed in a damage-
proof pack. When using the device it should be placed so that its indicating LEDs would be visible as
they inform in which working mode the device is in and if it has any working problems.
Protection against over current, short circuiting and earth faults should be provided as a part of the
building installation.
Signal level of the device depends on the environment in which it is working in. In case the device
starts working insufficiently, please refer to qualified personnel in order to repair this product. We
recommend forwarding it to a repair center or the manufacturer. There are no exchangeable parts
inside the device.

5
Introduction
Thank you for purchasing a RUT230 3G router! RUT230 is part of the RUT2xx series of compact
mobile routers with high speed wireless and Ethernet connections.
This router is ideal for people 
cumbersome cable connection. Unrestricted, but not forgotten: the router still supports internet
distribution via a broadband cable, simply plug it in to the wan port, set the router to a correct mode
and you are ready to browse.
For in-depth information on how to use and configure a RUT230 router, visit our wiki page:
http://wiki.teltonika.lt/index.php?title=RUT230
Hardware installation
1. Push the SIM holder with the SIM needle.
2. Pull out the SIM holder 3. Insert your SIM card into the SIM holder 4. Slide the SIM holder back into the router.
5. Attach 3G and WiFi antennas.
6. Connect the power adapter to the socket on the front of the device. Then plug the other end of
the power adapter into the power socket.
7. Connect to the device wirelessly (SSID: RUT230_001E42 ****** (unique to each device)) or use
an Ethernet cable and plug it into the LAN port.

6
Front and back panels
Front view
1. Power LED
2. Power socket
3. Mobile network type LED
4. SIM holder
5. Mobile signal strength indication LEDs
6. Ethernet ports
7. LAN LED
8. WAN LED
Back view
1. WiFi antenna connector
2. Reset button
3. 3G antenna connector

7
Configure your computer (Windows)
1. Enable the wireless network connection (go to Start >
Control Panel > Network and Internet > Network and
Sharing Center. In the left panel click Change adapter
settings link. Right click on Wireless Network
Connection and select Enable).
2. Setup the wireless network adapter on your computer
(right click on Wireless Network Connection and select
Properties). After that select Internet Protocol Version
4 (TCP/IP) and click Properties).
3. Select Obtain IP address automatically and Obtain
DNS server address automatically if they are not
selected. Click OK.
4. Right click on Wireless Network Connection
and click Connect to see available wireless
networks.
5. Choose the wireless network RUT230_001E42
****** from the list and click Connect.

8
Login to device
1. To enter the routers Web interface type http://192.168.1.1 into your internet browser
2. Use the following parameters when prompted for authentication:
3. Configuration Wizard will start after logging in. It is necessary to complete Configuration Wizard
to setup the router to the correct mode. You can leave default settings but it is strongly
recommended that you change the default password and enable Wireless Security.
4. Go to Status > Network information and pay attention to Signal Strength. To maximize the
performance try adjusting the antennas or changing the location of your device to achieve the
best signal conditions.

9
LED indications
Singal strength status LEDs turned on: the router is turning on
2G and 3G LEDs constantly blinking every 1 sec.: no SIM or bad PIN
2G/3G LEDs blinking every 1 sec.: connected to 2G/3G, but no data session established
Blinking from 2G LED to 3G LED every 1 sec.: SIM holder not inserted
2G/3G LED turned on: connected to 2G/3G with session
2G/3G LED blinking rapidly: connected to 2G/3G with data session and data is being transferred
Signal strength LEDs
No. of lit up LEDs
Signal strength value
0
-111 dBm
1
-110 dBm to -97 dBm
2 -96 dBm to -82 dBm
-96 dBm to -82 dBm
3
-81 dBm to -67 dBm
4
-66 dBm to -52 dBm
5
-51 dBm

10
Specifications
Ethernet
IEEE 802.3, IEEE 802.3u standards
1 x LAN 10/100Mbps Ethernet ports
1 x WAN 10/100Mbps Ethernet port
Supports Auto MDI/MDIX
Wi-Fi
IEEE 802.11b/g/n WiFi standards
AP and STA modes
64/128-bit WEP, WPA, WPA2, WPA&WPA2 encryption methods
2.401 –2.495GHz Wi-Fi frequency range*
20dBm max WiFi TX power
SSID stealth mode and access control based on MAC address
Hardware
High performance 400 MHz CPU with 64 Mbytes of DDR2 memory
External SIM holder
pin DC connector with 1 x Digital input and 1 x Digital output
Reset/restore to default button
1 x SMA for 3G, 1 x RP-SMA for WiFi antenna connectors
2x Ethernet LEDs, 1 x power LED
5x signal strength LEDs, 2 x connection type indication LEDs
Bottom and sideways DIN rail mounting slits
Electrical, Mechanical & Environmental
Dimensions (W x D x H) 83mm x 74mm x 25mm
Weight 125g
Power supply 100 –240 VAC -> 9 VDC wall adapter
Input voltage range 9 –30VDC
Power consumption < 5W
Operating temperature -40°to 75°C
Storage temperature -45°to 80°C
Operating humidity 10% to 90% Non-condensing
Storage humidity 5% to 95% Non-condensing
*Supported frequency bands are dependent on geographical location and may not be available in all markets

11
GPL
Some products of Teltonika partly contain software code developed by third parties, including
software code subject to the GNU General Public Licens
General Public License 
In order to comply with the terms of the GPL, Teltonika, where applicable, offers a mail in service of a
machine readable source code of the software subject to the GPL, on an optical media (CD-ROM)
upon request by mail or email. Further information is provided with the relevant products or the
software. You can download the free copies of the respective machine readable source code of the
software which is subject to the GPL and contained in Teltonika products if you follow this internet
link: https://teltonika.lt/gpl/
The respective programs are distributed WITHOUT ANY WARRANTY; without even the implied
warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the respective
GNU General Public License for more details.
Please choose the model and version of your Teltonika product from the list found in the provided link
in order to download the source code. You can also review and print the respective GPL license
terms.
If you have any more questions or suggestions regarding GPL, please contact us at [email protected]

12
CE Declaration of Conformity
2014/35/EU, 2014/30/EU. The full text of the EU declaration of conformity is available at
the following internet address: http://teltonika.lt/product/RUT230/
[EN] English
Hereby, Teltonika declares that the radio equipment type RUT230 is in compliance with
Directives: 2014/53/EU
[BG] Bulgarian
    RUT230  

[CZ] Czech
       RUT230     
2014/53/EU
[DK] Danish
  a, at radioudstyrstypen RUT230 er i overensstemmelse med
direktiverne: 2014/53/EU
[DE] German
        RUT230 den Richtlinien 2014/53/EU
entspricht
[EE] Estonian
      RUT230 vastab direktiividele:
2014/53/EL
[GR] Greek
 RUT230 

[ES] Spanish
Por la presente, Teltonika declara que el equipo de radio tipo RUT230 cumple con las Directivas:
2014/53/UE
[IT] Italian
Con la presente, Teltonika dichiara che l'apparecchiatura radio tipo RUT230   
direttive 2014/53/UE
[LV] Latvian
RUT230 
[LT] Lithuanian
RUT230 atitinka direktyvas: 2014/53/ES
[HU] Hungarian
A Teltonika kijelenti, hogy a RUT230     

[NL] Dutch
Hierbij verklaart Teltonika dat het RUT230-radioapparatuur voldoet aan de richtlijnen: 2014/53/EU
[PL] Polish
       RUT230 jest zgodne z
Dyrektywami: 2014/53/EU
[PT] Portuguese
            RUT230  
conformidade com as Diretivas: 2014/53/UE
[RO] Romanian
      RUT230     
2014/53/UE
[SK] Slovak
       RUT230     

[SI] Slovenian
Teltonika izjavlja, da je radijska oprema tipa RUT230 v skladu z direktivami: 2014/53/EU
[FI] Finish
RUT230 
[SE] Swedish
     RUT230   
2014/53/EU
[NO] Norwegian
     RUT230 er i samsvar med direktivene:
2014/53/EU