Teltonika RUT500 User manual

4
Login to device
1. To enter router’s Web interface type http://192.168.1.1 in your internet browser.
2. Use the following parameters when prompted for authentication:
User name: admin
Password: admin01
3. Configuration Wizard will start after logging in. It is necessary to complete Configuration
Wizard to setup router to correct mode. You can leave default settings but it is strongly
recommended that you change the password and enable Wireless Security.
4. Go to Status -> Network Information and pay attention to Signal Strength. To maximize
the performance try adjusting antennas or changing location of your device to achieve
best signal conditions.
This sign on the package means that
it is necessary to read the User’s
Manual before you start using the
device.
This sign on the package means
that all used electronic and electric
equipment should not be mixed
with general household waste.
Please visit our web site www.teltonika.lt for complete user manual
RUT500
HSPA+ Router
Quick start guide v1.7

2 3
Front Panel Back Panel
1Power socket
1GSM main antenna connector
2,3,4 LAN Ethernet ports
2Wi-Fi antenna connector
5WAN Ethernet port
3GSM auxiliary antenna connector *
6Power LED
4Reset button
7,8,9 LAN LEDs
5GSM LED
10 WAN LED
*- Unavailable in alternate model.
Hardware installation
1. Remove back panel and insert SIM card which was given by your ISP (Internet Service
Provider). Correct SIM card orientation is shown in the picture.
2. Attach GSM main and Wi-Fi antennas.
3. Connect the power adapter to the socket on the front panel of the device. Then plug
the other end of the power adapter into a wall outlet or power strip.
4. Connect to the device wirelessly (SSID: Teltonika) or use Ethernet cable and plug it
into any LAN Ethernet port.
Configure your computer
1. Enable the wireless network connection. (Go to Start > Control Panel > Network and
Internet > Network and Sharing Center. In the left pane click Change adapter settings
link. Right click on Wireless Network Connection and select Enable.
2. Setup wireless network adapter on your
computer (Right click on Wireless Network
Connection select, choose Internet
Protocol Version 4 (TCP/IP) and click
Properties)
3. Select Obtain IP address automatically
and Obtain DNS server address
automatically if they are not selected.
Click OK.
4. Right click on Wireless Network
Connection and select
Connect/Disconnect to see available
wireless networks.
5. Choose the wireless network Teltonika from the list and press Connect.