Teltonika RUT850 User manual

4
This sign on the package means that it
is necessary to read the User's
Manual before you start using the
device.
This sign on the package means that all
used electronic and electric equipment
should not be mixed with general
household waste.
3. Configuration Wizard will start after logging in. It is necessary to complete Configuration Wizard to
setup router to correct mode. You can leave default settings but it is strongly recommended that you change
the password and enable Wireless Security.
4. Go to Status > Network Information and pay attention to Signal Strength. To maximize the
performance try adjusting antennas or changing location of your device to achieve best signal conditions.
Login to device
1. To enter router's Web interface type in your internet browser.http://192.168.1.1
2. Use the following parameters when prompted for authentication:
User name: admin
Password: admin01
Please visit our web site for more informationwww.teltonika.lt
Hereby, Teltonika declares that this RUT850 is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC.
RUT850 Automotive Router
LTE is a trade mark of ETSI.
Quick start guide v2
CERTIFIED
ORGANISATION
ISO 9001

23
Hardware installation
1. Pull out SIM holder by pushing the button and insert SIM cards which was given by your ISP (Internet
Service Provider). Correct SIM card’s orientation is shown in the picture.
Front view
Configure your computer (using Windows 7)
Back view
3 LTE aux antenna connector
2. Attach LTE antennas.
3. Connect the power adapter to the socket on the back of the device. Then plug the other end of the power
adapter in to the power socket (or by your option).
4. Connect to the device wirelessly (SSID: rut850).
Choose the wireless network rut850
from the list and Connect.click
1. Push
the button
2. Pull out
the SIM holder
3. Insert
the SIM
4. Push in
the SIM holder
1 Power LED
5 2G LED
2 SIM holder
6 3G LED
3 Reset buttons
7 4G LED
4 WiFi LED
8 GSM signal strength indication LEDs
1 2 3 4
5 6 7
8
1 Power socket 2 LTE main antenna connector
1 2 3
Power socket pinout
No.
Description
Wire color
1
Not connected
White
2
Ignition
Green
3
Ground
Black
4
Power
Red
Enable the wireless network connection
( o to Start > Control Panel > Network g
and Internet > Network and Sharing
Center. In the left panel click Change
adapter settings link. Right click on
Wireless Network Connection and
select Enable).
1
2Setup wireless network adapter on your
computer ( ight click on Wireless r
Ne twork Co nnec t ion and se l ect
Properties. After that select Internet
Protocol Version 4 (TCP/IP) and click
Properties).
3S e l e c t O b t a i n I P a d d r e s s
automatically and Obtain DNS
server address automatically if
they are not selected. Click OK.
Right click on Wireless Network
C o n n e c t i o n a n d s e l e c t
C o n n e c t / D i s c o n n e c t t o s e e
available wireless networks.
4
5
12
34