Instructions Rev C
Introduction
2 Lift Connect™Part No. 1295251GT
Intr od ucti on
Observe and Obey:
This procedure shall be completed by a person
trained and qualified on the repair of this
machine.
Immediately tag and remove from service a
damaged or malfunctioning machine.
Repair any machine damage or malfunction
before operating the machine.
Before Starting Installation:
Read, understand and obey the safety rules
and operating instructions in the appropriate
operator's manual.
Be sure that all necessary tools and parts are
available and ready for use.
Read this procedure completely and adhere to
the instructions. Attempting shortcuts may
produce hazardous conditions.
Indicates that a specific result is expected
after performing a series of steps.
Indicates that an incorrect result has occurred
after performing a series of steps.
Note: These installation instructions only apply to
the Genie models and serial number ranges listed
within this document.
If you have any further questions regarding these
instructions or need assistance, please contact
Genie Product Support at one of the following
telephone numbers:
+ 46 3157
+ 97 143 391 800 o
- other
+ 1 425-
Genie, "S", "Z" and "ZX" are registered trademarks
of Terex South Dakota, Inc. in the U.S.A. and many
other countries.
"GR", "GRC", "GS", "GTH", "QS", "SX", "TZ", "XC"
and "TraX" are trademarks of Terex South Dakota,
Inc.
Tools Required:
11/32 inch socket
Ratchet
Torx T30 screwdriver
Cable tie gun or wire cutters
Mild cleaning solvent
Soft clean cloth
Squeegee
Optional tools may be required on various models.
