TerraKing ST22912 User manual

PRINTED IN USA FORM NO. 3-157 rev. (10/06/21)
TM
45-0580
12v OUT
12v IN
Remote Receiver Box
ST22912 Control FOB
ST22912
8ft Wire Harness Extension
ST43509
A (1) B (2)
C (1)

2
1. Stop machine on a level surface, not on a slope.
2. Disengage mower blades or any other attachments.
3. Lower attachments to the ground.
4. Lock the park brake.
5. Stop the engine.
6. Remove the key.
7. Wait for engine and all moving parts to stop before you leave the operator’s seat.
8. Close fuel shut-off valve, if your machine is equipped.
9. Disconnect the negative battery cable or remove the spark plug wire (for gasoline engines) before servicing
the machine
INSTALL REMOTE CONTROL / RECEIVER BOX
1. Plug the wires labeled "12v Out" into the pump or
motor side of your sprayer.
2. Expose adhesive backing located on the back of the
remote receiver box and adhere the receiver box (A)
close to the electric motor but out of the way of hoses,
cap or moving parts.
NOTE: Be sure surface is clean and dry prior to
adhering to sprayer. It is recommended to wipe
area thoroughly with alcohol or a non-residue
cleaning agent.
15 / 25 gal
45 / 60 gal
A
A

3
3. Install the 8 ft. wire harness (C) in place of your
switched harness following the same route. In the
event you choose to continue to use the switched
harness, make sure the switch is in the "on" position.
4. Connect the wire extension/switch harness to the fuse
battery lead or fused 12v plug in adaptor supplied with
your sprayer.
Specication
Max Amp…………………….15 amp
Required Batteries
Remote……………………….27A -12v
Maximum Range……………..100ft unobstructed*
*Range will vary depending on obstacles and battery life.
Transmitter Compliance Statement:
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Transmitters comply with all United States and Canadian
legal requirements as of the date of manufacture.
No warranty is made that they comply with all legal
requirements of any other jurisdiction. If transmitters are to
be used in another country, the importer must determine
compliance with any local laws and regulations which may
differ from United States and Canadian requirements prior
to use.
5. Attach control FOB (B) to key chain using the attached
clamp..
Note: the receiver box is epoxy sealed for weather
resistance. It is recommended that you wipe off the
receiver after spraying to help protect the integrity
of the sealer. The control FOB is NOT waterproof.
CAUTION: Avoid damage! Avoid damage
to wiring. Make sure hood does not close
on wiring harness. Keep wiring harnesses
away from all moving parts and hot
surfaces.
WARNING: Do not deploy this item for
emergencies involving re, security and
safety of life.
C

the fastest way to purchase parts
www.speedepart.com
© 2021 Agri-Fab, Inc.
REPAIR PARTS
Agri-Fab, Inc.
809 South Hamilton
Sullivan, IL. 61951
800-448-9282
www.agri-fab.com
This document (or manual) is protected under the U.S. Copyright Laws and the copyright laws of foreign countries, pursuant to the
Universal Copyright Convention and the Berne convention. No part of this document may be reproduced or transmitted in any form or
by any means, electronic or mechanical, including photocopying or recording, or by any information storage or retrieval system, without
the express written permission of Agri-Fab, Inc. Unauthorized uses and/or reproductions of this manual will subject such unauthorized
user to civil and criminal penalties as provided by the United States Copyright Laws.