Teufel AC 1001 SP Manual

Speaker stand
AC 1001 SP
Technical Description and
Operating Instructions
Proper use
Only use the speaker stand for mounting suitable speak-
ers. You can find a corresponding list on our website
www.teufelaudio.com. Any other use will be deemed as not in
accordance with the instructions and may lead to damage of
property or even persons.
The manufacturer accepts no liability for damage caused by
use not in accordance with the instructions. The product is
intended for private use.
Before operating the product for the first time,
please read the safety notes and operating instruc-
tions carefully. This is the only way to use all func-
tions safely and reliably. Keep the operating instructions safe
and pass them on to anyone who may own the unit after you.
Notice
The information in this document may change without prior
notice and in no way constitutes any liability on the part of
Lautsprecher Teufel GmbH. No part of these instructions may
be reproduced in any form or be broadcasted in any way elec-
tronically, mechanically, by photocopy or recording without
the written permission of Lautsprecher Teufel GmbH.
Original packaging
If you wish to exercise your right of return, we ask that you
be absolutely sure to hold onto the packaging. We can only
accept the return of a unit WITH THE ORIGINAL PACKAGING.
Empty boxes are not available!
Complaints
In case of a complaint we implicitly need your invoice number
and the serial or lot number for processing. The serial num-
ber is located on the bottom side of the device.
Many thanks for your support!
Contact
Please contact our customer service with any ques-
tions, suggestions or criticism:
Lautsprecher Teufel GmbH
BIKINI Berlin
Budapester Str. 44
10787 Berlin (Germany)
Phone 00800 - 200 300 40 (toll-free)
Fax: +49 (0)30 / 300 930 930
Service: www.teufelaudio.com/service
Contact: www.teufelaudio.com/contact
General notes and information

①2 x pipe
②2 x speaker bracket
③2 x fixing nut
④2 x holding screw
⑤4 x fixing screw
⑥2 x base plate
Check that all items have been delivered and that nothing is
damaged.
If anything is missing or damaged, please contact our service
department (see page 1). Do not use a product if it is dam-
aged.
Note:
You can find a current list with all the speakers that are
suitable for use with this speaker stand on our website at
www.teufelaudio.com.
Danger Danger of injury/damage!
Incorrect location may result in damage.
• Place the speakers in such a way that they cannot be
knocked over unseen and make sure that the cables do
not pose a trip hazard.
• Do not place the speakers near or directly above sources
of heat (e.g. heaters, ovens, other heat generating equip-
ment such as amplifiers etc.).
• Avoid direct sunlight at the setup location.
Danger Danger to children!
Children can become trapped in the packing film
when playing and suffocate.
• Do not allow children to play with the unit or the packing
film. Danger of suffocation.
Product contents
• Ensure that children do not remove small parts from the
unit or take them off of the unit (e.g. control knobs or plug
adapters). They could swallow the parts and choke.
Warning of damage to property!
The isolation pads can produce discolouration on
sensitive surfaces.
• On parquet, varnished wood and similar surfaces, you
should stick felt gliders to the rubber feet of the speaker
stand or put blankets or small carpets under them. This
will prevent discolouration of the floor over the long term.
Safety notes
⑥
③
④
⑤
①
②

Assembly
①
⑥
1. Screw the pipe ①into the base plate ⑥.
②
⑤
2. Place the speaker bracket ②on the upper end of the pipe
and fix it in place with the fixing screw ⑤.
3. Run the speaker cable through the upper hole and through
the pipe until it extends somewhat out of the opening in
the base plate. Then pull it through until there is sufficient
length left for connecting the speaker at the top.
Depending on the construction of your speakers there are 2
possibilities for mounting:
A) For speakers with a key hole opening
③
④
1. Insert the holding screw ④into the speaker bracket from
the front and first screw it loosely together with the fixing
nut ③.
2. Use the key hole opening to carefully hang the speaker on
the holding screw. Then firmly tighten the fixing nut.
3. Connect the speaker cables as described in the operating
instructions for the speakers.
B) For speakers with a threaded insert
⑤
1. Screw the speaker onto the speaker stand with the fixing
screw ⑤until secure.
2. Connect the speaker cables as described in the operating
instructions for the speakers.

Max. carrying capacity: 2 kg
Height: 960 mm
Diameter of base plate: 220 mm
You can obtain further technical data on our website.
Technical data
Noresponsibilityisassumedforthecorrectnessofthisinformation.Technicalchanges,typographicalerrorsandothererrorsreserved.InstructionNo.199910_20220111_EN/HC-HAM
Please contact our customer service department with any questions, suggestions, or
complaints:
Lautsprecher Teufel GmbH
BIKINI Berlin
Budapester Str. 44
10787 Berlin (Germany)
www.teufelaudio.com
Phone.: [phone] (toll-free)
Fax: +49 (0)30 - 300 930 930
Service: www.teufelaudio.com/service
Contact: www.teufelaudio.com/contact
No responsibility is assumed for the
correctness of this information.
Technical changes, typographical
errors and other errors reserved.