The Things Network Node User manual

The Things Network
Node assembly - Kickstarter
version 1.0
date: 05-01-2017
- ssembly of the Node
- ssembly of the Node packaging

Assembly of the Node
Notes:
Product arcles;
•Node-boom (A)
•Node-top (B)
•Node-middle (C)
•Node-PCB (D)
O the shel parts:
•2 phillips screws 3x8
•2 torq 'athead 3x8
ABC D

Step 1.
- Place Node-middle in Node-top
Notes: important that the rubber sleeve pushes into the plasc rib o the Node-top
Product arcles;
•Node-boom
•Node-middle
Bad
Good

Step 2.
- Place Node-pcb and fasten it with 2 athead sc ews
Notes:
Product arcles;
•Node-assembly
•Node-pcb
•2 'athead screws 3x8

Step 3.
- Place Node-bo"om and fasten it with 2 phillip sc ews
Notes:
Product arcles;
•Node-assembly
•Node-boom
•2 phillip screws 3x8

Step 4.
- A"ach s$cke to the back of the Node-bo"om
Notes:
Product arcles;
Node-assembly
Node-boom
Scker

Assembly of the Node packaging
Notes: this is an old carton sleeve design
Product arcles;
•Node- oam (A)
•Node-assembly (B)
•Carton sleeve (C)
ABC

Step 1.
- Place Node-assembly in Node-Foam
Notes:
Product arcles;
•Node-assembly
•Node- oam

Step 2.
- Place ca ton sleeve a ound Node-foam, secu e it with tape
- Ma k the 868 o 916 MHz co esponding with the Node F equency
Notes: this is an old carton sleeve design
Product arcles;
•Node- oam
•Carton sleeve