Thermador HNW Guide

5551 McFadden Avenue, Huntington Beach, CA 92649 • 800/735-4328
RO#8605 • 35-05-275A • ©BSH Home Appliances Corporation, 1998 • Litho in U. S. A.4/00
READ AND SAVE THESE INSTRUCTIONS
CARE AND USE FOR
WALL HOODS
(Turn Book Over for Installation
Instructions)
®
Model #
Serial #
HNW

Page2
WARNING - TO REDUCE THE
RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
CAUTION: FOR VENTILATION USE
ONLY. DO NOT USE TO EXHAUST
HAZARDOUS OR EXPLOSIVE
MATERIALS OR VAPOR.
1. Use this unit only in the
manner intended by the
manufacturer. If you have
questions, contact the
manufacturer (800/735-4328).
2. Before servicing or cleaning
the unit, switch power off at
service panel and lock service
panel to prevent power from
being switched on accidentally.
WARNING - TO REDUCE THE
RISK OF A RANGE TOP GREASE
FIRE.
a) Never leave surface units
unattended at high settings.
Boilovers cause smoking and
greasy spillovers that may
ignite. Heat oils slowly on low
or medium settings.
b) Always turn hood ON when
cooking at high heat or when
cooking flaming foods.
c) Clean ventilating fans
frequently. Grease should not
be allowed to accumulate on
fan or filter.
d) Use proper pan size. Always
use cookware appropriate for
the size of the surface
element.
IMPORTANT SAFETY INSTRUCTIONS
WARNING - TO REDUCE THE
RISK OF INJURY TO PERSONS,
IN THE EVENT OF A RANGE TOP
GREASE FIRE, OBSERVE THE
FOLLOWING:
a) SMOTHER FLAMES with a
close-fitting lid, cookie sheet,
or other metal tray, then turn
off the burner. BE CAREFUL
TO PREVENT BURNS. If the
flames do not go out
immediately, EVACUATE AND
CALL THE FIRE
DEPARTMENT.
b) NEVER PICK UP A FLAMING
PAN - you may be burned.
c) DO NOT USE WATER,
including wet dishcloths or
towels - a violent steam
explosion will result.
d) Use an extinguisher ONLY if:
1)You know you have a class
ABC extinguisher, and you
already know how to operate
it.
2)The fire is small and
contained in the area where
it started.
3)The fire department is
being called.
4)You can fight the fire with
your back to an exit.

Page3
LES INSTRUCTIONS DE SÉCURITÉ IMPORTANTES
AVERTISSEMENT - POUR
RÉDUIRE LE RISQUE
D’INCENDIE, DE CHOC
ÉLECTRIQUE, OU DE LA
BLESSURE AUX PERSONNES,
OBSERVER LE SUIVANT:
ATTENTION: SEULEMENT POUR
L’UTILISATION D’AÉRATION. NE
PAS L’UTILISER POUR ÉPUISER
LA VAPEUR OU LES MATIÈRES
EXPLOSIVES OU
DANGEREUSES.
1. Utiliser cet appareil
seulement dans la manière
destinée par le fabricant. Si
vous avez des questions,
contacter le fabricant (800/
735-4328).
2. Avant l’entretien ou le
nettoyage de l’appareil, couper
le courant au tableau de
service, et fermer à clef le
tableau de service pour
empêcher l’alimentation d’être
allumée par hasard.
AVERTISSEMENT - POUR
RÉDUIRE LE RISQUE D’UN FEU
DE GRAISSE DU SOMMET DE LA
CUISINIÈRE:
1. Garder le ventilateur, les
filtres et les surfaces chargées
de la graisse propres.
2. Toujours mettre le capot EN
MARCHE en cuisinant à la
haute chaleur.
3. Utiliser les hauts
positionnements du cuisinière
sur la cuisinière seulement
quand c’est nécessaire.
Chauffer l’huile lentement sur
un positionnement bas à
moyen.
4. Ne pas laisser la cuisinière
sans surveillance pendant la
cuisson.
5. Utiliser toujours les batteries
de cuisine et les ustensiles
appropriés pour le type et la
quantité de la nourriture
ayant préparée.
AVERTISSEMENT: - POUR
RÉDUIRE LE RISQUE DE
BLESSURE AUX PERSONNES
DANS L’ÉVÉNEMENT D’UN FEU
DE GRAISSE DU SOMMET DE
LA CUISINIÈRE, OBSERVER
LES SUIVANTS:
a) ÉTOUFFERLES FLAMMES
avec un couvercle ajusté,
une tôle du biscuit ou un
plateau métallique, puis
fermer le bec. SOYEZ
CERTAIND’EMPÊCHER LES
BRÛLURES. Si les flammes
ne s’éteindront pas
immédiatement, ÉVACUER
ET APPELER LE SERVICE DES
INCENDIES.
b) NE JAMAIS RAMASSER UNE
CASSEROLE EN FLAMMES -
Vous pouvez être brûlé.
c) NE PAS UTILISER DE L’EAU, y
compris les torchons
mouillés ou les serviettes -
une explosion violente
résultera.
d) Utiliser un extincteur
SEULEMENT si:
1) Vous savez que vous
avez un extincteur de Classe
ABC et vous. savez déjà
comment le faire
fonctionner.
2) Le feu est petit et est
contenu dans la région où il a
commencé.
3) Le service des
incendies est appelé.
4) Vous pouvez combattre
le feu avec votre dos à une
sortie.

Page4
A. Motor OFF button
B. ON button and motor speed
selection button 1, 2, 3, 1,....
C. Speed 1LED
D. Speed 2 LED
E. Speed 3 LED
F. Timer LED
G. Timer.
If the motor is off while the ti-
mer is pressed the motor will
run at speed 3 for 20 minutes
then stop.
If the motor is running when
the timer key is pressed the
motor will continue to run for 10
minutes. After 10 minutes the
motor will stop.
Pressing the timer or speed
button while the Timer LED is
on will disable the timed mode.
H. Light ON/OFF button.
I. Dim Light ON/OFF button.
Grease Filter Saturation LED
The speed 2 LED in Figure 1 in is
marked with an F. This LED will
flash to remind you when the grease
filter needs to be cleaned after 40
hours use. Follow the instructions
for cleaning filters in thisFollow
the instructions for cleaning filters
in this booklet. Once the grease
filters have been cleaned, reset
the display by pressing button Afor
Circuit Self-test
The control allows the user to
perform a self-test to check the
correct function of the hood.
The self test is activated by
pressing the Aand Bkeys
simultaneously for 3 seconds.
The self-test procedure order is:
1. Four LED’s switch on.
2. Four LED’s switch off.
3. Blower runs at speed 1.
4. Blower runs at speed 2.
5. Blower runs at speed 3.
6. Blower off.
7. Lights switch on.
8. Lights dim.
9. Lights turn off.
10. Beep signals end of self-test.
OPERATING
INSTRUCTIONS - HOOD
The blower should be turned on
for 10 minutes before cooking in
order to establish air currents
through the hood. This will
improve the capture and removal
of heat, smoke, moisture, grease
and cooking odors. Use the low
speeds for normal use and the
higher speeds for strong odors or
fumes.
Drafts across the range or
cooktop will reduce the effective-
ness of the hood. Such drafts
should be prevented when
possible.
CONTROL PANEL
MODEL: HNW
ELECTRONIC TOUCH CONTROLS
Fig. 1

Page5
CLEANING INSTRUCTIONS
Be sure lights are cool
before cleaning the hood.
To Clean Filter/s
•It is recommended that the
filters be washed at least
once a month; they can be
washed by hand or in the
dishwasher.
• Drain water through holes
along filter edges and allow to
dry thoroughly before
replacing it.
To Clean Hood Surface
• For general care, wipe the
outside of the stainless steel,
white, black or glass hood
with sudsy water or
household cleaners such as
Fantastic® or Formula 409®,
rinse well and dry with clean
soft cloth to avoid water
marks.
• Wipe and dry brushed
stainless steel in the same
direction as the grain.
• Do not use abrasive products.
• To remove finger prints and
give added shine use spray
cleaners such as Stainless
Steel Magic® and Shimmer®
FILTERS
The metal grease filters are
made of anodized aluminum and
are long lasting.
To Remove The Metal Grease
Filter/s
• Turn blower and lights off.
• Push each handle towards the
back and pull downwards Fig.
2.
To Replace The Metal Grease
Filter/s
• Reverse procedure.
LIGHTS
NOTE: Turn blower and lights
off. Make sure the lights are
cool. If new lights do not opera-
te verify lights are inserted
correctly before calling service.
Replace Lights For HNW
• Using a flat edge from a
screwdriver or equivalent tool
pry loose the lens cover as
shown in Figure 3.
• Remove the damaged light
and replace with a new 12
Volt, 20 Watt (maximum)
halogen light made for a G-4
base. Follow package
directions and do not touch
new light with bare hands.
• Reinstall the light cover.
Fig. 3
Fig. 2

Page6
THERMADOR HOOD WARRANTY
FULL ONE YEAR WARRANTY
Covers one year from date of installation, or date of occupancy on a new, or
previously unoccupied dwelling. Save your dated receipt or other evidence of
installation/ occupancy date.
Thermador
Will Not PayWill Not Pay
Will Not PayWill Not Pay
Will Not Pay For:
1. Service by an unauthorized agency. Damage or repairs due to service by an
unauthorized agency or the use of unauthorized parts.
2. Service visits to:
• Teach you how to use the appliance.
• Correct defects or repairs due to improper installation. You are respon-
sible for providing electrical wiring and other connecting facilities.
• Reset circuit breakers or replace home fuses.
• Correct damage caused from accident, alteration, misuse, abuse, im-
proper installation or installation not in accordance with local electrical
codes or plumbing codes, or improper storage of the appliance.
3. Service labor during limited warranty period.
4. Travel fees and associated charges incurred when the product is installed
in a location with limited or restricted access (i.e. airplane flights, ferry
charges, isolated geographic regions).
5. Repairs due to other than normal home use.
Thermador
Will PayWill Pay
Will PayWill Pay
Will Pay For:
All repair labor and replacement parts found to be defective due to materials and
workmanship.
Service must be provided by a Factory Authorized Service Agency, during normal
working hours. For a Service Agency nearest you, please call 800/735-4328.
This warranty applies to appliances used in residential applications; it does not
cover their use in commercial installations. The warranty is for products
purchased and retained in the 50 states of the U. S. A., the District of Colum-
bia and Canada. Should the appliance be sold by the original purchaser during
the warranty period, the new owner continues to be protected until the expira-
tion date of the original purchaser's warranty period. Products for use in
Canada must be purchased through the Canadian distribution channel to
ensure regulatory compliance and warranty coverage. This warranty gives you
specific legal rights. You may also have other rights which vary from state to
state.
HOW TO OBTAIN SERVICE
• Contact the Factory Authorized Service Agent in your area.
• Contact the Dealership where you purchased the appliance.
• Call the Thermador Customer Support Call Center at 800-735-4328.
• Write to us at: Thermador 5551 McFadden Avenue, Hunington Beach, CA
92649.