IMPORTANT SAFEW INSTRUCTION
READ AND SAVE THESE INSTRUCTIONS
This applianceconformsto the relevant safety
regulations.
Repairsshouldonly be canied ovt by qualified
specialists.
Improperlyexecutedrepairs can give riseto significant
hmrdsfor the user.
A
Your new appliancewas protected on its way to
you by the packaging. Noneof the materials
cause
pollutionto the environmentand all can berecy-
cled for use again. Pleasehelpto protect the
environmentand disposeof the packaging in an
environment-friendiymanner.
You can obtain informationabout the best
method
disposingof old appliances and packaging from
your dealer or localmunicipalcouncil.
A
Check whether this fan may becombined with
the extractor hood.
A
SAFETY WARNING: Before servicingor cleaning
unit, switch poweroffat the service panel and
lock service disconnectingmeans to prevent
power from being switched on accidentally.
When the servicedisconnectingmeans cannot
be locked, attach
a
tag tothe servicepanel to
indicate power has beenswitched offfor
maintenance.
A
WARNING
-
TO REDUCETHE RISK OFFIRE,
ELECTRICSHOCK, OR INJURY TO PER-
SONS, OBSERVETHE FOLLOWING:
A. Installationwork and electricalwiring must be
done by qualified person(s)in accordance with all
applicablecodes and standards, includingfire-
relatedconstruction.
8. Sufticient air is neededfor propercombustion
and exhaustingof gases throughtheflue
(chimney)offuel burning equipment to prevent
back drafting. Followthe heatingequipment
manufacturersguideiine and safetystandards
such as those publishedby the NationalFire
ProtectionAssociation(NFPA), and the American
Societyfor Heating,Refrigeration andAir
ConditioningEngineers(ASHRAE), and the local
code authorities.
C. When cutting or drilling into wall or ceiling, do not
damagealectricalwiring and other hidden utilities.
D. To properlyexhaustair, besure to duct air out
side. Do not vent exhaustair into spaces within
walls, ceilings, attics, crawl spaces, or garages.
A
WARNING: To reducethe risk of fire, use only
metalductwork.
A
CAUTION
-
For General Ventilating Use Only.
Do Not Use To Exhaust HazardousOr Explosive
Materials And Vapours.
A
This unit must be grounded.
A
WARNING: To reducethe risk of fire or electric
shock, do not use this fan with any solid-state
speed control device.
Equipment
Needed
U
Drilland Bit
U
Sc~rewdriver
O
RubberMallet
Equipment
Included
0
Anchors
(4)
0
Screws
(4)
U
lnstallationInstructions
0
Connector
PAGE
1
