Thor Broadcast H-HDPerformux- 8 User manual

Login instructions:
In order to log in to the Modulator NMS port, please set your PC's NIC Ethernet card
to the following IP address: 192.168.0.100.
Access Modulator GUI by typing derail IP address 192.168.0.136 in to the browser
Login /password – admin/admin
Quick configuration Guide for H-HDPerformux- 8/16/24
https://thorbroadcast.com 800-521-8467 [e-mail]
Ver.2023
11
3
4Channel Input HDMI Setting Selection
5Video Bitrate
setup
6
HDMI Video Input
Lock indicator
Turns Green if the
signal is detected
6
Apply button for any parameters changes, to save it
permanently – Go to CONFIGURATION Tab and SAVE
Encoder Channels
Video Audio encoding
setup
for CH 1-8 , 9-16, 17-24

TS Config Program Information setting
https://thorbroadcast.com 800-521-8467 [e-mail]
1
3
HDMI inputs encoded
transport streams
2
4
Stream Select
SPTS ( single program transport stream or
MPTS (Multiprogram transport stream selection)
Parse the program
(scanning function)
This page controls which HDMI Input CH 1-24 or ASI or USB (in MPTS ) are selected and moved to the
IPTV outputs
By default all 24 channels are selected
Name
Program PID’s
Information
Click Digit 1 to 24 to open
Program information page

Configuration Saving / Backup / Restore
1. Click the pencil icon for MPTS’s or SPTS’s section. Drop box will open to configure channel 1
2. Enable and edit your IP preferences
3. Press apply
1. Click the configuration tab on the left hand side
2. Click the save tab
3. Press save config –
YOU MUST SAVE OR ALL CHANGES WILL BE LOST AFTER RESTART!
IPTV streaming is sent out from the data port and can be tested using VLC player.
UDP syntax example is udp://@224.2.2.2:2001
RTP syntax example is rtp://@224.2.2.2:2001
RTSP syntax example is rtsp://( DATA IP ADRESS):5000/1-4
SAVE Backup to PC Restore
https://thorbroadcast.com 800-521-8467 [e-mail]
1
IP Stream Setup
Multicast or unicast IP address
Port number
UDP or RTP or RTSP selection
Apply
ENABLE ON/OFF
Total Bit rate – need to
be > than Video Bit rate
Null Packet ON/OFF Function