Thrane&Thrane Sailor 6216 User manual

What’s in the box?
Dimensions for the VHF
How to install the VHF on desktop and overhead
How to install the VHF flush mount
INSTALLATION GUIDE
SAILOR 6215/6216 VHF DSC
Drilling plan on desktop and overhead
Cable assembly for waterproof installation
How to prevent water ingress
99-130249
4 x M4 or hole for
self-tapping ø3.9
150mm
53mm
71mm
196mm
23mm
9mm
Tilting ±20°
1.
2.
3.
4.
Connect the 4 cable connections with rubber vulcanizing tape as shown .....
Note!
- Firmly tie back and secure any wires not used in order to
avoid possibility for mutual shorting or shorting to ground!
- To ensure waterproof sealing:
If the surface isn’t plane and/or rigid remove the gasket and
seal with silicone sealant between the VHF and the surface.
Very important information!
Do not remove the membrane.
If you remove the membrane the radio will not be waterproof.
Membrane
U-Mounting
Bracket
Transceiver Gasket
Flush Mount
Bracket (2 pcs.)
Sun Screen
Fuse
6.3x3.2mm (10AT)
Hand Microphone
Wheel Knob
(2 pcs.)
Screw M4x45
TORX 20
(5 pcs.)
Square Nut
M4x7x2.2
(5 pcs.)
Screw M4x12
TORX 20
(5 pcs.)
Screw ø3.9x19
TORX 20
(5 pcs.)
Cap for LTW BD/BU
Connector
(2 pcs.)
Connection Cable,
1 m
Cradle
User & Installation Manual
Screw M4x12
TORX 20 (3 pcs.)
Screw ø3.9x19
TORX 20 (3 pcs.)
Power Cable
Connector for Hand Microphone or Handset - If not used, put the cap
from the ACC connector on the front connector to prevent water ingress.
AA
B B
99-130248
Gasket
Flush Mount Bracket (2 pcs.)
Screw M4x45 TORX 20 (4 pcs.)
Connect to LOUD HAILER
(RED isolation on inner connector)
Connect to EXT. SPEAKER
(WHITE isolation on inner connector)
Connect to POWER +
(RED wire)
Connect to POWER -
(BLUE wire)
Square Nut M4x7x2.2 (4 pcs.)
Max wall thickness 26mm
All manuals and user guides at all-guides.com
all-guides.com

[e-mail] •thrane.com
98-128470-THR-I
Handset
Microphone
VHF DSC
GPS in (NMEA 0183)
Cable
Service
Loud Hailer (4 ohm)
Speaker (8 ohm)
External
ACC. Port
Power
Handset Option
SAILOR 6205
SAILOR 6201
SAILOR 6201
99-129890-D
SAILOR 6215/6216
Hand Microphone
SAILOR 6202
12V DC
110/220V AC
GPS
GPS,
Control Speaker
SAILOR 6207
Connection Box
for parallel handsets
CTRL
ACC
Chart Plotter
N163S
Aerial
RX/TX
SAILOR 6090
12V Battery
24V DC
Power Converter
Note!
Firmly tie back and secure any wires not used in order to avoid
possibility for mutual shorting or shorting to ground!
Pin assignments
Front View
Wire color Pin
Brown 1
Blue 2
White 3
Green 4
Yellow 5
Grey 6
Pink 7
Red 8
1
2 9
8
7
6 10 3
4 5
Black 9
10 Orange - SCREEN (Drain)
NMEA in+
NMEA in-
NMEA out-
NMEA out+
Mike 2 / Line in
EAR 2 / Line out
Hook_PTT
Battery Supply when radio is on
Internal GND = - Battery
Internal GND = - Battery
Description
99-130891-B
How to install the GPS - Cable Connections
Pin assignments
Front View
Wire color Pin
Brown 1
Blue 2
White 3
Green 4
Yellow 5
Grey 6
Pink 7
Red 8
1
2 9
8
7
6 10 3
4 5
Black 9
10 Orange - SCREEN (Drain)
NMEA in+
NMEA in-
NMEA out-
NMEA out+
Mike 2 / Line in
EAR 2 / Line out
Hook_PTT
Battery Supply when radio is on
Internal GND = - Battery
Internal GND = - Battery
Description
99-130891-B
For further information, please download the installation
manual part no. 98-135548 at http://esupport.thrane.com
Flush mount template
Remove material from shaded area only!
99-129294
89mm
177mm
R2.5mm x 4
Cutout for flush mounting of the VHF System Configuration - Example
Dimensions for Hand Microphone - how to install the cradle Accessorie - SAILOR 6205 Control Speaker Microphone
Cradle
99-129296
2 x M4 or hole for
self-tapping ø3.9
34.6mm 46.8mm
28.5mm
Scale 1:1
IMPORTANT!
If this template was printed from an electronic
file or copied, scaling (1:1) may not be correct.
Consequently do not attempt to use a printed
or copied template without prior checking of
dimensions.
Cradle
Brown, Pin 1, NMEA in +
Blue, Pin 2, NMEA in -
For waterproof installation use
rubber vulcanizing tape
GPS Cable (NMEA 0183)
99-130267
All manuals and user guides at all-guides.com