TIE DOWN LongRun 86295 User manual

Modular 2” x 6” Bunk Guide On’s
Installation Instructions
Part #86295/86296
A935; 051216
Instruction Sheet #08096 Page 1 of 2
WARNING WARNING WARNING WARNING
Boat Glide On's greatly reduce friction between boat and trailer bunk boards. Winch must be locked and winch
line must be securely attached when launching, loading and transporting boat on trailer. Failure to keep boat
secured at all times to boat trailer can result in serious property damage, personal injury and/or possible death.
Prior to towing - always securely connect winch line, bow chain and transom tie down straps
Part 86295 - Kit contains the following components:
# Qty. Part # Description
1 4 46966 Center Bunk Slide (Black)
2 4 46964 12” End Bunk Slide (Black)
3 48 10630 #10x3/4” Stainless Steel Self Tapping Screws
Part 86296 - Kit contains the following components:
# Qty. Part # Description
1 4 46966W Center Bunk Slide (White)
2 4 46964W 12” End Bunk Slide (White)
3 48 10630 #10x3/4” Stainless Steel Self Tapping Screws
12” End Section (2)
36” Center Section (1)
Self Tapping Screws (3)
Fig. 1
Glide On
Bunk Board
Side View/Rear end
RIGHT
Slide Glide On UP
until it stops without
riding up the bunk
WRONG
The Glide Ons are to be used on 2x6 bunk board lumber
without any carpeting between the Glide Ons and wood.
1. Remove any carpet or other covering materials from bunk
boards. Remove any brackets, screws, staples or other
materials in order to have a clean work surface on top and
both sides of the bunk boards.
2. Starting at the rear of the trailer, slide one of the 12” end
section Glide Ons onto the 2x6 lumber with the open side to
the front of the bunk board. Push the Glide On section onto
the lumber until it is almost flush with the end of the bunk
board (see Fig 1).

Modular 2” x 6”
Bunk Guide On’s
Installation Instructions
Part #86295/86296
A935; 051216
Instruction Sheet #08096 Page 2 of 2
WARNING WARNING WARNING WARNING
Boat Glide On's greatly reduce friction between boat and trailer bunk boards. Winch must be locked and winch
line must be securely attached when launching, loading and transporting boat on trailer. Failure to keep boat
secured at all times to boat trailer can result in serious property damage, personal injury and/or possible death.
Prior to towing - always securely connect winch line, bow chain and transom tie down straps
Rear
Front
12” 36” 36” 12”
Reinforced
Mounting
Area
3. Attach the 12” end section with the self tapping
screws into the reinforced areas indicated on
the sides of the Glide Ons.
4. Slide the 36” Glide On up to the interlocking
end of the secured Glide On. (see Fig 2).
5. Attach using self tapping screws into the
reinforced areas indicated on the sides of
the Glide Ons. Repeat for the next 36“ section.
6. Place a 12” end section into the interlocking
end of the attached 36” section.
7. Complete installation with the self tapping screws into the reinforced areas indicated on the sides of
the Glide Ons. The 12” Bunk Glide Ons may extend over the front end of the bunk, that's OK (not over the rear).
8. Repeat steps 2-7 for the opposite side bunk.
Fig. 2