MAKE SURE THAT SPEAKER IS MOUNTED
WITH THE SIDE INDICATED BY THE ARROW UP.
IF THE SPEAKER MOUNTED UPSIDE DOWN.
RAINWATER GE T S INTO THE SPEAKER FROM
DRAIN HOLE ON THE BOT T OM PL ATE.
CAUSING BREAKDOWNS OR ACCIDENTS.
WHEN MOUNTING. BE SURE TO USE TOA’S
OPTIONAL BRACKET SOLELY DESIGNED FOR
MOUNTING THIS SPEAKER. WHEN USING
OTHER BRACKET. IT MUST HAVE STRENGTH
ENOUGH TO STAND THE SPEAKER WEIGHT.
2. FEATURES
The HA-1010 is long range speaker slim array is composed of multiple horn speaker positioned in an array. It
features
long-range sound coverage further than conventional horn speakers, narrowly focused vertical directivity that
allows
excessive volume to be controlled at closer proximity, and form a continuous linear sound source, achieving uniform sound
pressure with less attenuation due to distance.
3. INSTALLATION PRECAUTIONS
•
This long range slim array speakers
have
feature a drain hole built into same
panel
that holds the speaker cord. For
proper
drainage, when installation please
ensure
that this panel faces down toward
the
ground or follow the instruction of
direction
label at the rear case.
•
When using the other bracket, please to use
TOA’s optional bracket solely designed
for
mounting this speaker or it must
have
strength enough to stand the
speaker
weight.
Step 3.
Install the long range slim array to the
bracket
that have been installed to the mounting
surface
using supplied hexagon bolt, washer, and spring
washer
to top and bottom bracket.
Top bracket
Hexagon bolt M8 x 20
Spring washer (for M8)
Washer (for M8)
HA-1010
Washer (for M8)
Spring washer (for M8)
Hexagon bolt M8 x 20
Speaker cord
3. INSTALLATION
Step 1.
Make the sign for drill guide at the surface
or
location that can structurally support the weight
of the speaker. Prepare the proper dyna
bolt
that suitable with hole of bracket.
Dimensions
of sign for drill guide and hole of bracket
as
shown in the picture.
Holes bracket
4 - Ø9
50
(1.97”)
Unit: mm (in)
Guide for
top bracket
Surface for drill
Note
When the speaker installation need slope angel, use
the
optional Q-HA-1100 speaker bracket.
4. SPEAKER CORD COLOR CODING
Bottom bracket
Mounting Bracket
(accessory)
Guide for
bottom bracket
Step 2. Drill the surface that have been marked, install
the proper dyna bolt then the both of top
and
bottom bracket.
Note
Dyna bolts and nuts are not provided.
50
(1.97”)
Speaker cord
For connections,
refer to the table.
5. WIRING DIAGRAM
Nut
Mounting surface
Wiring diagram
Mounting Bracket
(accessory)
Dyna bolt
