Toaster Labs Pulse User manual

Pulse™ and Pulse Pods™ are Trademarks
of Toaster Labs, Inc.
Patent Pending
Made in the USA
Toaster Labs, Inc.
2212 Queen Anne Avenue Noh
Suite 269
Seale, WA 98109
Telephone: [phone]
Website: lovemypulse.com
©2015 Toaster Labs, Inc. All rights reserved.

Pod Chamber Control
Open / Eject Buon
Drop Dish
Power Po
Brightness Slider
Moodlight Control
Activation Beam

1. Pulse Set-up
Remove the Pulse, the Pulse Pods and place on a firm, level suace.
Plug your Pulse Warming Unit into a nearby electrical outlet.
2. Inseing a Pulse Pod
Select a Pulse Pod and remove the cap. Press the Open/Eject Buon
to open the Pod Chamber Door. Inse Pulse Pod with prongs facing up.
Press down on the Pod Chamber Door to close.

4. Dispensing Lubricant
Slide your fingers through the invisible activation beam and hold for 2 seconds.
The Pulse Warmer will deliver a pre-measured poion of warmed lubricant.
Lubricant stays warm while white light is steady.
Press the Power Control to begin warming the Pulse Pod. The pulsing white
light indicates the Pod is warming. Warming time is approximately 3-4 minutes.
The white light is steady when Pod is ready.
3. Heating the Pulse Pods
Power Control

6. Removing the Pulse Pod
Make sure the Power Control light is off. Press the Open/Eject Buon.
Remove the Pulse Pod. Replace Pod cap or discard if empty.
1 See Locking and Unlocking. 2 See Troubleshooting on the Product Manual Brochure.
White
(constant)
Lubricant is
warmed and
ready
White
(pulsing)
Lubricant is
warming
Amber
(flashes)
Only 1 poion
of lubricant
remains
Blue
(pulsing)
Unit is locked
and will not warm
or dispense
lubricant1
Red
(constant)
The Pod is empty
Red
(pulsing)
Pulse Warmer
error2
5. Power Control Cues
The Pulse Warming unit has been designed for ease-of-use with
various LED lighting cues to communicate to you about ceain functions.

8. Locking and Unlocking
The Pulse Warming Unit can be locked for safety.
To lock, press and hold down the Power Control Buon until a blue light flashes.
To unlock, press and hold down the Power Control Buon until the blue light disappears.*
*Your Pulse will automatically turn-off one hour aer last use.
7. Mood Light
Mood light has 6 colors to match your mood. Tap the Mood Light Control
to turn on light. Press and hold to find the Mood Light you want. Glide your fingers
up or down spine to adjust brightness. Tap the Mood Light Control to turn off.
Brightness Slider
Moodlight Control