Tonny TE1-0601 User manual

Automatic Soap Dispenser User ManualFeaturesModel：TE1-06011534621. Spout 2. Infrared sensor sender3. Battery compartment4. On/Off Switch & Liquid Soap Volume Control5. Container lid 6.Blue LED indicateInstallation · Open cover on battery compartment, and install 3 “AA”batteries with correct polarity(Note the +/- indication)· Open the soap container (Figure 1)· Fill with liquid soap· Ensure that soap container is closed with the disprn-ser.(Figure 2) · To turn on, press on the power button and adjust the soap volume control to the setting what you requirement· Put your hand under the sensor within 0-2 inch to let the dispenser start to work. Operation The on/off switch is located on the machine topIt is a three position switch:·Press once- Blue led light flashes 1 time then off and indicates power on and in use with low volume liquid soap; LED will flicker in dispensing·Press twice- Blue led light flashes 2 times then off and indicates power on and in use with high volume liquid soap; LED will flicker in dispensing· Press 3rd time- Power offNotice: For first time use, press once, then press on the button till the soap drops Attention· Place the dispenser on a flat, level surface.· This product is for indoor use. Exposure to direct sunlight will destroy the sensor system.· Use liquid soap with a low concentration of alcohol.· Avoid placing this product in areas where it could become covered in water.· Keep the liquid clean.· If you will not be using the dispenser for an extended period of time, empty the container of soap, clean the dispenser out and remove the batteries. Store it in a dry place.· Do not subject the On/Off switch to too much exposure to water.Recommended Usages: · Use non-granular, non-foaming liquid soap or hand sanitizer.· Clean dispensing tip regularly and run pump with warm water solution.· Not to be used with rechargeable batteries.Battery Low Indication ·If LED continues to flash blue the indication is positive to replace the batteries.Technical DateFigure 1Figure 2Dimension Vol Unit weight Plastic Material Battery type Rated Voltage Sensor Range Waterproof L96*W105*H227mm/ L3.8*4.1*8.9 in380mL /12.8 oz320g / 0.68 lbABS3 X 1.5V “AA” Alkaline4.5V0-5cm / 0-2 in.IP X4