Topkodas GTCOM2 User manual
HOW TO
Control primary alarm panel
from GTCOM2 ?
ARM/ DISARM methods:
•Touch iButton keys to the reader
•Send SMS to the module
•Call to the module
•ARM/ DISARM via mobile, web app
How to
Control primary alarm panel from GTCOM2
Via iButton keys, short call, SMS, mobile, web app?
Prepare the module GTCOM2
•Insert SIM card
•Screw GSM antenna
•Connect iButton reader
•Connect the module to the primary panel
•Connect the module to the computer via mini USB
Attention!
•Disconnect power supply before wiring!
•The correct wiring procedure is as follows:
•Make sure power is turned off
•Make wiring connections to the terminals
•Apply power
The module can work with any central panel which has PSTN communicator and
meets Ademco Contact ID data format according to SIA SIA DC-05 standard.
Also Central panel must support phone number dialing using DTMF tones.
More information about GTCOM2 and primary alarm panel synchronization:
https://www.topkodas.lt/downloads/
GTCOM2 user manual
orange
yellow
black
red
Before You start, update firmware
Attention!
•If you want to edit existing configuration,
•You have to read it (press “Read” in the command line)
•Edit settings
•Write edited configuration (press “Write” in the command line)
•Go to SERA2> System Options> General System Options
•Set 1W (1- wire Bus) to Dallas 1- Wire Bus DS1990A/ DS18b20
•Press “Write” in the command line
•Press “Start iButton/RFID/ Phone programming mode” button
Start iButton, phone number entering mode
•Go to SERA2> Users/ Access control window
•Touch iButton keys to the reader
•Go to System Options> General system Options
•Press “Stop programming “ button
•Enter your phone number in the list
•Press “Write”
•Go to SERA2> Users/ Access Control window
•Modify list
•Press “Write” in the command line
Test the system
•Go to SERA2> RT Testing & Monitoring> Hardware
•Press “Start Monitoring” button
•Go to SERA2> RT Testing & Monitoring> Security Alarm Panel/ Access
•Touch iButton keys to the reader
•You will see the status of the system
•Go to SERA2> RT Testing & Monitoring> Security Alarm Panel/ Access
•You will see the real time status
Other manuals for GTCOM2
2
Table of contents
