TorcUP TU Series User manual

Maintenance Supplies
1. TU-20 Cylinder 2. Marine moly 3. Light grease 4. reaker bar with 7/8” socket 5. 1” square socket 6. TU-20
gland wrench 7. rass drift 8. Flat tip screw driver 9. Center punch 10. 5/32” allen wrench 11. 3/8” allen wrench
12. ¼” allen wrench 13. Ratchet 14. Hammer (32oz) 15. Dead blow hammer 16. Hammer (18oz.)
1.
2.
3.
4.
5.
6.
7.
8. 9.
10.
11.
12.
13. 14.
15.
16.

TU-20 Tool

Remove reaction
arm by depressing
gate lever

Remove 1st shroud
screw using 5/32”
allen wrench

Remove 2nd shroud
screw using 5/32”
allen wrench Note tension on shroud
will spring open once
screws are removed

View showing two
screws removed

Remove 3rd shroud
screw using 5/32”
allen wrench

Remove 4th shroud
screw using 5/32”
allen wrench

Remove housing
threaded
plug using 3/8”
allen wrench

Flip tool over and
remove housing
threaded plug on
opposite side

Remove 1st retract
screw using 3/8”
allen wrench

View of 1st retract
screw after removal

Remove 2nd
retract screw using
3/8” allen wrench

View of 2nd
retract screw
after removal

Remove threaded
retainer

View showing threaded
retainer after removal

Remove
square drive

Remove 1st
retaining ring
using small flat
tip screw driver

Remove 2nd
retaining ring
using small
flat tip screw
driver