TorcUP RAPTOR RP Series Setup guide

Repair Instructions
2nd Stage Raptor Replacement

Tools required:
3/16 inch allen wrench, pliers & bin for balls

Remove ball plug with allen wrench

Showing plug removed

Place Raptor over bin so balls will drop into bin

Write here
Rotate annulus alternately counter clockwise
allowing balls to drop out

•G:\Raptor_BreakApart\expor\Raptor_Asse
mble (10).jpg
Write here
Showing a ball dropping out

Write here
Continue turning until all balls are out and annulus
comes from motor

Write here
Pull apart gearbox from motor and check to ensure
gears are in gear housing as shown

Write here
Use socket to position gearbox vertically for stability

Write here
Stable gearbox positioned

Write here
Use pliers to remove 1st stage gears, keep
components on a clean surface

Write here
Remove 2nd gear

Write here
All gears removed

Write here
Remove 1st stage carrier, keep components on a
clean surface

Write here
Remove all three 2nd stage gears

Write here
Remove 2nd stage carrier

Write here
Old 2nd stage carrier on right,
new carrier shown on left

Write here
Lubricate new 2nd stage carrier
with Mobil synthetic grease

Write here
Lubricate liberally as shown