TorcUP TX LINK Series Operating manual

Maintenance
Supplies
1. TX Link 2. Marine moly 3. 5/32” allen wrench 4. 3/16” allen wrench
1.
2.
3.
4.

Detach ratchet link from cylinder.
Remove 1st lower spacer screw
using 3/16” allen wrench

Remove 2nd lower
spacer screw using 3/16”
allen wrench

Remove 1st upper
spacer screw using
5/32” allen wrench

Remove 2nd upper
spacer screw
using 5/32”
allen wrench

Remove ratchet link sideplate

Remove ratchet link sideplate
Image shown illustrates
factory assembly using
Mobil 1 synthetic grease

Remove ratchet, drive plate
and drive segment

Slide ratchet
from drive
plate
Be aware of tension on segment spring
to prohibit spring ejection

Separate drive
segment from
ratchet

Clean and inspect tool

Use marine grade moly lube
Mobil 1 synthetic
grease also suitable

Grease inside of drive plate

Grease inside
of sideplate

Grease inside bronze sleeves

Grease inside
of sideplate

Wrong Direction Correct Direction

Align ratchet and drive
segment with drive plate

Insert drive
segment spring
and press into
drive plate