1Press : Move the louver in the
desired vertical direction.
2Press : Swing the air automatically
and press again to stop.
3For horizontal direction, adjust manually.
DANGER
Do not install, repair, open or remove the cover. It may expose you to•
dangerous voltages. Ask the dealer or the specialist to do this.
Turning off the power supply will not prevent potential electric shock.•
The appliance shall be installed in accordance with national wiring•
regulation.
Means for disconnection from the supply having a contact separation of•
at least 3 mm in all poles must be incorporated in the fixed wiring.
WARNING
Do not expose your body directly to cool air for a long time.•
Do not insert your finger or any article into the air inlet/outlet.•
When an abnormality (burning smell, etc.) occurs, stop the air•
conditioner and disconnect the power supply or turn off the breaker.
This appliance is not intended for use by persons (including children)•
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do not play with the•
appliance.
Do not use any refrigerant different from the one specified for•
complement or replacement. Otherwise, abnormally high pressure may
be generated in the refrigeration cycle, which may result in a failure or
explosion of the product or an injury to your body.
CAUTION
Do not wash the unit with water. It may cause an electric shock.•
Do not use this air conditioner for other purposes such as preserving•
food, breeding animal, etc.
Do not step or put anything on the indoor/outdoor unit. It may cause an•
injury or damage the unit.
Do not touch aluminium fin because it may cause an injury.•
Before cleaning the unit, turn off the main switch or the circuit breaker.•
When the unit won’t be used for a long time, turn off the main switch or•
the circuit breaker.
It is recommended that maintenance be performed by a specialist when•
the unit has been operated for a long time.
The manufacturer shall not assume any liability for the damage caused•
by not observing the description of this manual.
PRECAUTIONS FOR SAFETY
INDOOR UNIT DISPLAY
1Hi POWER (Green)
2FILTER (Orange)
3PURE (Blue)
4TIMER (Yellow)
5OPERATION (Green)
6RESET button
1
Infrared signal emitter
2
Memory and preset button (PRESET)
3
Start/Stop button
4Temperature up/down and Timer
or clock up/down button (TEMP.)
5
Mode select button (MODE)
6
Swing louver button (SWING)
7
Fan speed button (FAN)
8
One Touch button (ONE-TOUCH)
9
Set louver button (FIX)
0
8 degree celcius operation button (8°C)
-
Economy button (ECO)
=
High power button (Hi-POWER)
~
Plasma Air Purifier button (PURE)
!
Comfort sleep button (COMFORT SLEEP)
@
Power selection button (POWER-SEL)
#
On timer button (ON)
$
Off timer button (OFF)
%
Setup button (SET)
^
Clear button (CLR)
&
Clock setup button (CLOCK)
*
Check button (CHECK)
(
Filter reset button (FILTER)
)
Reset button (RESET)
1
Hi POWER FILTER PURE TIMER OPERATION
RESET
12
3
45
6
PREPARATION BEFORE USE
2
Preparing Filters
1. Open the air inlet grille and remove the air filters.
2. Attach the filters. (see detail in the accessory sheet).
Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type) following the (+)
and (–) positions.
Clock Setup
1. Push by tip of the pencil.
2. Press : adjust the time.
3. Press : Set the time.
Remote Control Reset
Press for reset.
AIRFLOW DIRECTION
3
Note:
Do not move the louver manually by others.•
The louver may automation positioning by some operation mode.•
REMOTE CONTROL
4
ONE-TOUCH
5
Press the “ONE-TOUCH” button for fully automated operation that is customised
to the typical consumer preferences in your region of the world. The customised
settings control temperature air flow strength, air flow direction and other settings
to provide you alternate contact with “ONE-TOUCH” of the button. If you prefer
other settings you can select from the many other operating functions of your
Toshiba unit.
Press : Start the operation.
AUTOMATIC OPERATION
6
To automatically select cooling, heating, or fan only operation
1. Press : Select A.
2. Press : Set the desired temperature.
3. Press : Select AUTO, LOW , LOW+ , MED ,
MED+ , HIGH , or Quiet .
COOLING / HEATING / FAN ONLY OPERATION
7
1. Press : Select Cool , Heat , or Fan only .
2. Press : Set the desired temperature.
Cooling: Min. 17°C, Heating: Max. 30°C, Fan Only: No temperature indication
3. Press : Select AUTO, LOW , LOW+ , MED ,
MED+ , HIGH , or Quiet .
Note: QUIET is supper low fan speed for quiet operation.
DRY OPERATION (COOLING ONLY)
8
For dehumidification, a moderate cooling performance is controlled automatically.
1. Press : Select Dry .
2. Press : Set the desired temperature.
AIR PURIFYING OPERATION
9
During air conditioner operation
Press to start and stop plasma air purifier and air ionizer operation.
The plasma air purifier and air ionizer can be activated or deactivated during air
conditioner is stopped and the air ionizer starts in conjunction with plasma air
purifier operation.
Note: The FILTER indicator (orange) turns on after PURE operation is performed
for about 1000 hours.
Hi-POWER OPERATION
10
To automatically control room temperature and airflow for faster cooling or heating
operation (except in DRY and FAN ONLY mode)
Press : Start and stop the operation.
ECO OPERATION
11
To automatically control room to save energy (except in DRY and FAN ONLY
mode)
Press : Start and stop the operation.
Note: Cooling operation; the set temperature will increase automatically 1
degree/hour for 2 hours (maximum 2 degrees increase). For heating
operation the set temperature will decrease.
1
4
6
7
9
11
12
14
15
19
18
23
22
3
2
5
8
10
13
16
17
20
21
