TOUCHBeauty TB-1951 User manual

TB-1951 Electric Nose Hair Trimmer
Safety Instructions
※Important Notice: This manual is available in two languages: English and Simplified
Chinese. If any dispute or confusion arises caused by the translation, the English version shall
prevail.
※To ensure proper operation of this device, please read this instruction manual carefully
before using the device and keep it for further reference.
WARNING
This device is not a toy, keep out of reach of children.
Please verify the device before you start using it. Do not use this device if you detect
any damage or malfunction.
Please, keep the USB cable and the device charging port dry.
Do not use the device while charging.
CAUTION
Do not use this device under the following conditions: if you have allergies; if you have
wounds, inflammation, or lumps in the area of use.
This device is not intended for use by persons (including children) with reduced physical,
or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning the use of the device by a person
responsible for their safety.
Immediately discontinue use and consult a doctor if you feel any discomfort during use.
Never insert the trimmer head too deep into your nose to avoid injuries.
Keep the device out of reach of children.
Regularly clean the device and the accessories to extend its lifetime.
Do not share the same device with others.
Do not attempt to disassemble, repair, or modify the device by yourself to avoid
accidents.
This device has a lithium battery. Do not place or store the device for a long time in a
hot or humid place. If you do not intend to use the device for a while, store it with the
battery full. Do not throw the device into a fire or dispose of it in the general household
waste. Please hand this device to an official recycling point.
1. Device Specifications
Name: Electric Nose Hair Trimmer

Model No.: TB-1951
Input: 5V /0.5A
Power: 3.7V /1W
Type of Battery: Li-ion 3.7V 300mAh
Executive Standard: Q/XMMJ1009-2015
2. Device Description
1Protective Cap
2Trimmer Head
a) Outer Head
b) Inner Blade
3Battery Indicator
4Touch Switch Sensor
5USB Charging Port
6Soft Rubber Plug
7USB Cable
8Cleaning Brush
3. Certification Marks
4. Preparing the Device for Use
※This device battery is low before use. Please charge the device with the USB cable before
you start using it.
※The device has a low battery & voltage reminder. When the battery is low, the inner
blade stops rotating, the battery indicator flashes red 10 times, and the device switches off
automatically to prevent hair from getting stuck due to low motor voltage and slower blade
rotation.
※The device has a stall protection system. If you don’t trim nose hair properly and hair
gets stuck, the motor stops working, the blades stop rotating, and the battery indicator
flashes 10 times red. If you cannot get the hair from stalling the device, it will repeat the
above reminder until you can remove it.
Charging the Battery:
Connect one end of the USB cable to an adapter and the other end to the device’s USB
charging port located on the bottom of the device. Plug the adapter into a wall outlet.

The battery indicator will flash a red light indicating the device is charging. The device
battery is full when the battery indicator illuminates a steady blue light.
A fully charged device should last for about 60 minutes of continuous use. This device
can be used approximately 30 times based on a 2-minute use.
Caution: Do not attempt to replace the device battery.
5. How to Use
To ensure the correct operation of this device, please read the instructions carefully before
use.
5.1 Remove/Attach the Trimmer Head
Remove: To remove the trimmer head, grab the device with one hand (please be
careful not to grab the touch switch sensor area), and use the other hand to rotate the
trimmer head counterclockwise. Pull to remove the trimmer head. Remove the inner
blade from the outer head. (Picture 2)
Attach: Insert the inner blade into the outer head. Place the trimmer head on the device,
and rotate it clockwise. Make sure you do not touch the touch switch sensor area when
attaching the trimmer head. (Picture 3)
5.2 Trimming Steps
Remove the protective cap. When you grab the device on the touch switch sensor area
and the trimmer head touches the nostril, the device switches on automatically.
(Picture 4)
Slowly insert the tip of the trimmer head into your nostril. Do not insert the tip of the
trimmer head deeper than 0.5cm. (Picture 5)
After using the device, you may notice some residual hair inside of your nostril. Use a
tissue paper or a cotton swab to remove any residual hair. Clean the device after each
use.
※Area of use: nose.
※After each use, clean the device with a clean slightly wet cloth. Remove the outer head
and inner blade, clean with the cleaning brush, and rinse it with water. Afterward, insert
the inner blade into the outer head, place it on the device, and rotate clockwise. Put the
device protective cap on. Store the device in a dry, well-ventilated place to extend its
lifetime.

6. Cleaning & Maintenance
※To ensure the best performance of the device, clean the body, inner and outer blade
before and after each use.
Make sure the blades are not rotating when cleaning the device. Do not touch the
touch sensor switch area.
This device is water-resistant. However, do not immerse it in water.
Clean the device’s body with a clean slightly wet cloth after each use. Remove the outer
head and the inner blade, clean it with a cleaning brush and rinse it with water.
Do not use steel wool, abrasive cleansers, chemicals, or corrosive liquids to clean the
device.
Do not use lubricants, detergents, polishing agents, or air fresheners on this device.
7. Storage
This device has a lithium battery. Do not place or store the device for long periods in a hot or
humid place. If you do not intend to use the device for a while, store it with the battery full.
8. Recycling
The built-in battery contains substances that may pollute the environment. When disposing
of this device, do not put it in the general household waste. Please dispose of this device in
an official recycling point to contribute to environmental protection.
9. Warranty & Support
Troubleshooting
Problem
Possible Cause
Solution
The device does not work
properly.
The battery is running low or
out of power.
Charge the device as guided in
this instruction manual.
The trimmer head is not
installed correctly.
Install the trimmer head correctly
as guided in this instruction
manual.
Abnormal noise when using
the device.
The outer head/inner blade
is not installed correctly.
Install the outer head/inner blade
correctly as guided in this
instruction manual.

Other Problems.
Consult your local dealer.
Note: If the device still does not work properly after using the above solutions, please stop using
the device and contact your local dealer.
After-Sales Service
Please visit our website www.touchbeauty.com or contact our customer service team
[e-mail] if you need to learn about our products or if you need any
information. You can also contact an affiliate dealer in your country.
MANUFACTURER: TOUCHBEAUTY BEAUTY & HEALTH (SHENZHEN) CO., LTD
ADDRESS: 601 & 602, Block F5, TCL International E-City, 1001 Zhongshanyuan Road,
Shuguang Community, Xili Subdistrict, Nanshan District, Shenzhen, China.