TP-Link TL-SG1005D User manual

© 2020 TP-Link
7106508780 REV9.1.0
Installation Guide
5/8-Port Gigabit Desktop Switch
Note: For simplicity, we will take TL-SG1005D for example throughout this Guide.
LED Explanation
Connection
TL-SG1005D
PC PC
Router
LAN PortWAN Port
Internet
5 4321POWER
Power Adapter
Ethernet Ports (1-5)
Power
On: Power on
O: Power o
Link/Act
On: Link present but no activity
Flashing: Transmitting/receiving data
O: No link

IEEE802.3, IEEE802.3i, IEEE802.3u, IEEE802.3ab,
IEEE802.3x, IEEE802.1p
CSMA/CD
5/8 10/100/1000 Mbps Auto-Negotiation RJ45 Ports
10BASE-T: UTP category 3, 4, 5 cable (maximum 100 m)
EIA/TIA-568 100ΩSTP (maximum 100 m)
100BASE-TX: UTP category 5, 5e cable (maximum 100 m)
EIA/TIA-568 100ΩSTP (maximum 100 m)
1000Base-T: UTP category 5e cable (maximum 100 m)
EIA/TIA-568 100ΩSTP (maximum 100 m)
Power, Link/Act LEDs
Ethernet: 10 Mbps (Half Duplex), 20 Mbps (Full Duplex)
Fast Ethernet: 100 Mbps (Half Duplex), 200 Mbps (Full
Duplex)
Gigabit Ethernet: 2000 Mbps (Full Duplex)
QoS (802.1p/DSCP Priority)
Store-and-Forward
Automatically learning, automatically aging
10Base-T: 14881 pps/Port
100Base-Tx: 148810 pps/Port
1000Base-T: 1488095 pps/Port
Standard
Protocol
Data Transfer Rate
Transfer Method
MAC Address Learning
Frame Foward Rate
General Specications
Interface
Network Media (Cable)
LED Indicators
The Power LED should be lit when the power system is working normally. If
the Power LED is not lit, please try the following:
A1: Make sure the power cord is connected to the switch with power source
properly.
A2: Make sure the voltage of the power supply meets the requirements of
the input voltage of the switch.
A3: Make sure the power source is ON.
Q1. Why is the Power LED not lit?
Please try the following:
A1: Make sure that the cable connectors are rmly plugged into the switch
and the device.
A2: Make sure the connected device is turned on and works normally.
A3: Try to change the connected device’s transmission speed and duplex
mode.
A4: The cable must be less than 100 meters long (328 feet).
Q2. Why is the Link/Act LED not lit when a device is
connected to the corresponding port?
Frequently Asked Questions (FAQ) Specications
0 ˚C to 40 ˚C (32 ˚F to 104 ˚F)
10% to 90% RH non-condensing
5% to 90% RH non-condensing
Operating Temperature
Operating Humidity
Storage Humidity
Environmental and Physical Specications
Advanced Features
Some models featured in this guide may be unavailable in your country or region. For local
sales information, visit https://www.tp-link.com.
Wall Mountable
Distance Between
Mounting Holes
Ye s
TL-SG1005D: 60 mm
TL-SG1008D: 100 mm
EU declaration of conformity
TP-Link hereby declares that the device is in compliance with the essential requirements and other
relevant provisions of directives 2014/30/EU, 2014/35/EU, 2009/125/EC, 2011/65/EU and
(EU)2015/863.
The original EU declaration of conformity may be found at https://www.tp-link.com/en/ce.
Продукт сертифіковано згідно с правилами системи УкрСЕПРО на відповідність вимогам
нормативних документів та вимогам, що передбачені чинними законодавчими актами України.
Safety Information
Use only power supplies which are provided by manufacturer and in the origin packing of this
product. If you have any questions, please don’t hesitate to contact us.
Do not use any other chargers than those recommended.
Keep the device away from water, re, humidity or hot environments.
Adapter shall be installed near the equipment and shall be easily accessible.
Do not use damaged charger or USB cable to charge the device.
Do not attempt to disassemble, repair, or modify the device. If you need service, please contact us.
Place the device with its bottom surface downward.
For technical support and other information, please visit
https://www.tp-link.com/support, or simply scan the QR code.
If you have any suggestions or needs on the product guides,
welcome to email [e-mail].
To ask questions, find answers, and communicate with TP-Link users or engineers,
please visit https://community.tp-link.com to join TP-Link Community.