TREND T/TFR-4 User manual

1
T/TFR-4 Temperature Sensor Installation Instructions TG200660 Issue 1/D 19/03/07
Important: Retain these instructions
Installation Instructions
T/TFR-4
Thermistor Flying Lead Sensor
Installation Instructions,
TG200504
Unpacking
Dimensions
1
Installation
4mm
(0.16”)
18 mm (0.71”)
4 m (13’)
Requirements
2b
a
c
e
dfg
h
H O
2
-10 °C
(14 °F) +50 °C
(122 °F) 0%RH 90 %RH
0 °C
(32 °F) +40 °C measurement
(104 °F)

2T/TFR-4 Temperature Sensor Installation Instructions TG200660 Issue 1/D 19/03/07
T/TFR-4 Installation Instructions
Manufactured for and on behalf of the Environmental and Combustion Controls Division of Honeywell Technologies Sàrl, Ecublens, Route
du Bois 37,Switzerland by its Authorized Representative.
Trend Control Systems Limited reserves the right to revise this publication from time to time and make changes to the content
hereof without obligation to notify any person of such revisions or changes.
Trend Control Systems Limited
P.O. Box 34, Horsham, West Sussex, RH12 2YF, UK. Tel:[phone] Fax:[phone] www.trend-controls.com
Trend Control Systems USA
6670 185th Avenue NE, Redmond, Washington 98052, USA. Tel: [phone], Fax: [phone] www.trend-controls.com
WEEEDirective:
Atthe endoftheir usefullife thepackaging
and product should be disposed of by a
suitable recycling centre.
Do not dispose of with normal household waste.
Do not burn.
MountSensor
3
Installation
Disposal
Wire to controller
4
grommet
IQ1x, IQ2xx
C
IN Analogue
input channel
linked for
thermistor
(T)0 (0V)
N (in)
+ (24V)
IQ3
Set up IQ Sensor types
5
TestSystem
6
tYpe Sensor digI/P Driver Function loGic Loop scHedule seQnc Analog
digBit Knob sWitch Time Zone Oss User addRess intcoN calarM reView Plot
calEndar
= ?
Thermistor (-10 to +50 °C, 14 to 122 °F)
Yn<CR>
TYPEn
:
=?
S=5 (characterise)
Y=, E=, U=, L=, P=,
I1 to I6=, O1 to O6=
X<CR>
It is recommended to use SET (software tool) for the setting of sensor type modules. For all IQ2 series controllers with
firmware version 2.1 or greater, or IQ3 series controllers, one of the the following SET Unique Sensor References should
be used:
Thermistor TFR-4 (°C)
Thermistor TFR-4 F (°F)
Alternatively enter scaling manually as defined in the table below.
For all other IQ controllers see Sensor Scaling Reference Card TB100521A.
stinUC°F°
YepyttupnI)stlovrotsimreht(1
EtnenopxE3
UreppU05221
LrewoL01-41
PstnioP6
xxIxO
1146.205221
274.304401
364.40368
4366.60
105
5866.7023
6201.85-32
IQ
IfIQ ΔT