TRENDnet TEG-S081Fi User manual

TEG-S081Fi
Quick Installation Guide

English ......................................................................................................
Troubleshooting ........................................................................................
1
1
2
3
5
1. Before You Start
2. How to Connect .................................................................................
3. Using the Switch ................................................................................
.................................................................................
Table of Contents
Version 10.13.05

1. Workstations with network cards
2. TCP/IP protocol installed in all workstations
3. Aweb browser such as Internet Explorer or Netscape Navigator
4. Multimode Fiber cable with SC-type connectors.
5. Multimode Fiber converters with SC-type connectors or a switch with an SC-
Type Fiber port.
System Requirements
TEG-S081Fi
Accessories
AC power cord
RS-232 cable
Quick Installation Guide
User’s Guide CD ROM
Package Content
Servers with 32-bit PCI
Fast Ethernet Card
(TE100-PCIWA)
Accounting Department
Workstations with 32-bit PCI
Fast Ethernet Card
(TE100-PCIWA)
Workstations with 32-bit PCI
Fast Ethernet Card
(TE100-PCIWA)
Sales Department
8-port 10/100Mbps
Fast Ethernet Mini Switch
(TE100-S88Eplus)
5-port 10/100Mbps
Fast Ethernet Mini Switch
(TE100-S5Pplus)
8-port 10/100Mbps
Fast Ethernet Mini Switch
(TE100-S8P)
MIS Department
8-Port 100Base-FX Layer 2 Managed Switch with GBIC Slot
(TEG-S081Fi)
Internet
100Mbps
TFC-110MSCE
TFC-110MSCE
1. Before You Start
English
1

1. Connect theAC Power cord to the back of
the TEG-S081Fi.
2. Connect the fiber cable to the front of the
switch and your Network.
3. Verify that the PWR led displays a solid
green light.
2. How to Connect
English
2

1. Go to Start ? Settings ?
Control Panel.
2. Double-Click the Network
Connection Icon.
3. Right-Click Local Area
Connection, and select
Properties.
3. Using the Switch
English
3

Note: For more detail on advanced features, please consult the User's Guide.
Your installation is now completed.
7. Select the appropriate option to
configure the SNMP switch.
6. User Name: root
Password: root
5. Open your web browser, type
http://192.168.16.1, and press
Enter.
4. Please configure your PC's IP
address to 192.168.16.x.
English
4

Q1.
A1.
Q2.
A2.
Q3.
A3.
Q4.
A4.
How come I cannot see any light from any of my LED's?
Your TEG-S081Fi is not getting any power. Make sure that your surge protector or your
outlet is getting power and make sure that theAC Power cord is properly connected to your
TEG-S081Fi .
I connected my fiber converter to the TEG-S081Fi using a Multimode Fiber cable with SC
connectors. However, the network activity LED does not blink. What should I do?
Go to the TEG-S081Fi and move the connector that was in the transmit side to the
receive side, and the other connector that was in the receive side to the transmit side.
I changed my IP settings to 192.168.16.222 to access the switch, but I still cannot get
into the Web configuration page. What should I do?
Make sure there is no other network device using the same IP address. Afterwards,
consult the User's Guide to access the switch through the Console Port. Once you reach the
command line interface, perform a factory reset and try again.
I performed a factory reset on the TEG-S081Fi, but I still cannot access the web
configuration page. What should I do?
If you are configuring more than one TEG-S081Fi, then it is possible that you are
experiencing IP conflict between these two switches. Please configure each switch one at a
time, and make sure you assign a unique IP address to each switch.
If you have any questions regarding the TEG-S081Fi, please contactTRENDnet’s Technical
Support Department.
Certifications
This equipment has been tested and found to comply with FCC and CE Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received.
Including interference that may cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FORANY RADIO ORTV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONSTO THIS EQUIPMENT. SUCH MODIFICATIONS
COULD VOID THE USER’SAUTHORITYTO OPERATE THE EQUIPMENT.
Waste electrical and electronic products
must not be disposed of with household
waste. Please recycle where facilities
exist. Check with you Local Authority or
Retailerforrecyclingadvice.
5
Troubleshooting

Copyright ©2006. All Rights Reserved. TRENDnet.
3135 Kashiwa Street
Torrance, CA 90505
USA
TRENDnet Technical Support
Tech Support Hours
24/7 Toll Free Tech Support
Contact
Telephone: [phone]
Email: [email protected]
Contact
Tech Support Hours
Telephone:
Deutsch :+49 (0) 6331 / 268-460
Français :+49 (0) 6331 / 268-461
0800-90-71-61 (numéro vert)
Español :+49 (0) 6331 / 268-462
English :+49 (0) 6331 / 268-463
Italiano :+49 (0) 6331 / 268-464
Dutch :+49 (0) 6331 / 268-465
Fax: [phone] / 268-466
8:00am - 6:00pm
Middle European Time
Monday - Friday
Product Warranty Registration
Please take a moment to register your product online.
Go to TRENDnet’s website at http://www.trendnet.com
US/Canada Support Center European Support Center