TREX Outdoor Furniture TXS60 User manual

E - 5/16-18 NYLOCK NUT
2
B - .27 X 2-1/2 SOCKET WAFER A
4
C - 5/16-18 X 2 EYE BOLT SS
4
F - .307 X 2-1/2 X 3/4 S-HOOK ZN2
COATING DETERMINED BY LOCATION OF USE
(1) Seat Model: TXS60
Assembly Instructions
(1) Back
pg 1 of 3
(2) Sideframes
•
1
1/2" wrench•
6/2/2011
Layout Parts
3
Layout Hardware
2
Tools Needed
4mm Hex Key, T-Handle•Screwdriver
ALL HARDWARE IS STAINLESS STEEL
UNLESS OTHERWISE NOTED
Qty
G - SNAP HOOK 1/4"
4
D - 5/16 X 3/4 OD FLAT WASHER
6
H - 5FT ZINC CHAIN4
A - 1/4-20 X 1-3/4 WAFER SHCS
6

A
AA
B
Swing Assembly
1
2
3
Attach the side frames to the seat using
(4) 1-3/4" SHCS bolts by fastening
them from the inside. May need to lay it back
to access those holes.
DO NOT TIGHTEN
UNTIL AFTER STEP 2
Insert back assembly into the
sideframe pockets and fasten with
(2) 1-3/4" SHCS into the tube at the top
and (2) 2-1/2" screws thru sideframe
into the pilot hole on back assembly.
Add (2) 2-1/2" screws thru the back
into pilot holes on the seat supports
The bolts installed on Step 1 can now
be tightened.
SUGGESTION: If you can put this on a work
table it will be easier to put together.
FRONT
BACK
BACK - Insert (2) eyebolt and washer thru
sideframe and tighten down on the inside
with a washer and nylock nut.
FRONT - Insert (2) eyebolts with a washer
thru front of sideframes into insert nuts
on the apron of the seat assembly.
DE
CD
DC
seat assembly apron

4
pg 3 of 3
Tip: hanging mounts should be about 68" apart
Tip: Seat should measure about 18" from floor
Adjust this chain for height
(9ft porch max)
Adjust this chain for comfort
S-hook
Note: once comfort is set, S-hook
can be closed with tool
Snap hooks
Hang the swing