Triad OnWall Bronze Suround User manual

Triad OnWall Surround Speaker Installation Instructions - Quick Start Guide 2014.28.2
Specifications
Applicable Models Dimensions Frequency Response Sensitivity Rec Amp Pwr Impedance Weight lbs/kg
Inches / cm +/-3dB 2.83v, 1m Per Channel Nominal
OnWall Bronze Surround 12.6x13.25x4; 32x33.7x9 100 Hz - 16 kHz 84 dB 25-125 Watts 4 ohms 11 / 4.9
OnWall Silver Surround 13.5x14.25x4; 34.3x36.2x9 80 Hz - 20 kHz 85 dB 50-150 Watts 4 ohms 15 / 7
OnWall Gold Surround 13.5x26x4; 34.3x66x9 70 Hz - 20 kHz 87 dB 50-250 Watts 4 ohms 22 / 10
Additional Info
Triad dipole Surround Speakers ship in left & right pairs with opposite polarity. Arrow on top of each speaker should point toward the TV or screen. See Triad Surround Speaker
Placement & Polarity below for details.
North American Limited Warranty
Triad speakers are warranted to be free from defects in manufacturing and workmanship (10) years when operated under normal conditions. Should any such defects occur within
the warranty period call Triad Service at 1-503-256-2600 for an RA (Return Authorization) number. Return the product in intact factory packaging with RA number clearly visible on
outside of box and proof & date of purchase inside to:
Triad Speakers Inc., 15835 NE Cameron Blvd., Portland, Oregon 97230 USA
Triad is not responsible for any shipping damage coming in to Triad. If you do not have intact factory packaging, contact your dealer or Triad Service for purchase. At our discretion
we will repair or replace the product and return it free of charge. International customers should contact their dealer for service. This limited warranty is extended only to Triad
products and is expressly in lieu of all other warranties expressed or implied.
Unpacking / Contents
Surround Speaker
(Model Varies)
Hardware Package
(anchors & screws)
TriadSpeakers.com • Sales: 1800-666-6316
OnWall Surround - Product Info & Warranty - Page 1
(4) #8 x 1-1/2”
Pan Head
Phillips Screws
(4) #8-10-12
Ribbed Plastic
Wall Anchors.
Screw notch location
Surround Grill
(Model Varies)
LEFT CENTER RIGHT
+
SIDE
SUR
-
+
SIDE
SUR
-
A
LEFT CENTER RIGHT
+
SIDE
SUR
-
+
SIDE
SUR
-
B
LEFT CENTER RIGHT
+
SIDE
SUR
-
+
SIDE
SUR
-
C
-
SIDE
SUR
+
-
SIDE
SUR
+
LEFT CENTER RIGHT
+
SIDE
SUR
-
+
SIDE
SUR
-
D
-SIDE SUR + + SIDE SUR -
LEFT CENTER RIGHT
+
SIDE
SUR
-
+
SIDE
SUR
-
E
-
SIDE
SUR
+
-
SIDE
SUR
+
-SIDE SUR ++ SIDE SUR -
Triad Surround Speaker Placement & Polarity:
Triad Surround Speakers are dipoles (center null with left & right sides out of phase) as standard with bipoles as an option.
Side Channels: A. Place at 90-110 degrees off axis of primary listener with + polarity toward screen or TV. B. If 1 pair
of sides is meant to cover 2 rows, place them between rows with + polarity toward screen or optimize for 1 row. C. If 2
pairs are used as sides, for front pair follow rule A.; for back pair reverse left & rights with – polarity toward screen.
Back Channels: D. With 1 pair of side speakers, place back pair with + polarity and arrow toward room center. E. With
2 pairs of side speakers, place back pair with + polarity and arrow toward corresponding side wall.

Triad OnWall Surround Speaker Installation Instructions - Quick Start Guide 2014.28.2
Tools:
Remove speaker and screw one #8 x 1.5” screw
into marked location. Use anchor if there is no stud
behind the mark. Leave approx ½ inch (1.27 cm) of
threads protruding from wall. Pull enough speaker wire
out of the wall to reach speaker.
Set speaker’s screw notch on the screw while
supporting the other side. Level or align speaker.
Mark the remaining three holes with pencil.
B
AC
Route speaker cables up raceway on speaker back.
Connect speaker cables to binding posts with bare/ tinned
wires, pins or spades preserving polarity (+/-, Red/Black)
with amp. Partially fix the remaining bottom screw, again
leaving approx ½ inch (1.27cm) protruding from wall.
Support speaker on the two screws protruding through
the bottom screw notches. Fix the two upper screws
through the upper screw notches. Tighten all 4 screws.
Confirm speaker is attached to the wall securely.
Press fit the grill to the face of the speaker.
F
E
Install any remaining anchors that are needed.
D
At least 12
inches
(30.5cm)
Ceiling
Arrow points
to TV or
Screen*
At least
24 inches
(61cm)
OnWall Surround - Installation Instructions - Page 2
+ -
+
Screw Notch Location
* For detailed Surround placement instructions,
see Triad Surround Speaker Placement & Polarity
on Page 1 (on the opposite side of this page).
Position speaker on the wall with arrow facing the
TV or Screen*. Proper orientation has woofer on top.
Speaker bottom should be at least 24 inches above
seated ear height; speaker top at least 12 inches below
ceiling. With a pencil, mark 1 of the 2 bottom screw
notches on the wall. If possible, position at least one
bottom screw notch directly over a stud.