TRIDENT AIR MINI-2
www.tridentair.sg pg. 9
CLEANING & MAINTENANCE
AIR INLET GRILLE AND OUTLET LOUVER CLEANING
1. To get rid of dust and debris, use a soft brush. Or use a slightly damp cloth to clean the louvers.
2. Avoid using any abrasives or cleaning pads on any sections of the equipment and, if necessary, use a
paper or cloth that has been mildly moistened to remove big deposits.
VOC SENSOR CLEANING
Above the air inlet grille, on the machine's middle right side, is where you'll find the VOC sensor.
1. To preserve precise smell identification, wipe away dust and debris from the VOC sensor using a soft
cloth.
2. Avoid tampering with the opening, or spraying water near the grille aperture above the VOC sensor as
this could void the sensor's warranty.
PM2.5 SENSOR CLEANING
1. Remove the PM2.5 Sensor cover.
2. Clean the lens, air intake, and air output with a damp cotton swab.
3. To get rid of any remaining water stains on the dust sensor, use a dry cotton swab.
4. Clean the PM2.5 sensor whenever readings is erratic.
CLEANING OF STAINLESS STEEL MESH PRE-FILTERS
Depending on the environment in which it is used, the aluminum mesh filter needs to be cleaned at least once
every four months. It captures big particles >5 microns onwards, and pet dander, hair, tiny insects etc.
1. Use a vacuum cleaner to get rid of any dust or fluff.
2. Apply mild detergent and wash with a shower head.
3. Rinse the filter well to get rid of any remaining soap.
4. Air-dry or use hair dryer to dry the filters.
CLEANING OF CAGE FILTERS
1. Remove CAGE filters.
2. Place it in water with mild detergent and let it soak for 5 minutes.
3. To eliminate all dirt, use a shower head to spray clean.
4. Let the sun dry the filter or make use of a hair dryer.
CLEANING OF OZONE EMISSION REMOVAL FILTER
1. To get rid of dust and fluff, use a vacuum cleaner or soft brush to brush off dust.
2. DO NOT wash with water.
CLEANING OF COLD PLASMA ACTIVATOR
1. Remove stainless steel mesh from the tube and rinse with water.
2. Clean dust off the quartz tube.
3. Install mesh back onto glass tube when dry.
WHOLE MACHINE CLEANING
1. Clean with a damp sponge or cloth.
2. DO NOT immerse the whole set into water.
