Trikdis iO-LORA User manual

RF-LORA transceiver and iO-8-LORA,
iO-LORA wireless expanders
Quick installation guide
Wireless expanders iO-8-LORA, iO-LORA with RF-LORA module
increase the number of inputs and outputs of the "FLEXi" SP3 contol
panel using two-way RF communication.
iO-8-LORA has 8 input/output terminals that can be configured as
input or output.
iO-LORA has 1 input, 1 relay output, „1-Wire“ data bus for connecting
temperature sensors (up to 4 pcs.) and a iButton key reader.
Visit the iO-8-LORA, iO-LORA page on trikdis.com for device
specifications and an updated list of compatible TRIKDIS devices.
Follow the steps below to set up iO-8-LORA, iO-LORA:
1. Connect the RF-LORA transceiver to the "FLEXi" SP3 control panel,
and iO-LORA, iO-8-LORA to the power supply, as shown:
2. Input connection diagrams and resistor values are determined by
the „FLEXi“ SP3 control panel, to which the iO-8-LORA, iO-LORA
modules are connected.
3. Schematics for connecting a relay and an LED indicator:

4. Connect a USB cable to the „FLEXi“ SP3 control panel and open
TrikdisConfig software. Press Read [F4].
5. Go to the "Modules" window and click on an empty row in the
"RS485 Modules" area. Select iO-8-LORA Expander (iO-LORA
Expander) from the drop down list as shown:
6. Enter the serial number of the iO-8-LORA (iO-LORA) expander in
the field on the right (enter numbers only). You will find serial
number on the sticker on iO-8-LORA (iO-LORA).
7. The „Zones“ and „PGM“ outputs menu windows will now display
the inputs and outputs of the iO-8-LORA (iO-LORA) expanders that
you can activate:
8. Make the necessary settings and press Write [F5] and disconnect
the USB cable.
9. Trigger the inputs and switch outputs to test the device.
Visit for support:
www.trikdis.com