Tripp Lite SRWB6210STR User manual

1
Installation Guide
Wire Basket Cable Trays
Models:
SRWB6210STR
(AC8AFB)
SRWB12210STR
(AC8AFC)
SRWB6410STR
(AC8AFD)
SRWB12410STR
(AC8AFE)
SRWB18410STR
(AC8AFF)
Este guía esta disponible en español
en la página de Tripp Lite:
www.tripplite.com/support
Ce guide est disponible en français
sur le site Web de Tripp Lite :
www.tripplite.com/support
Русскоязычная версия настоящего
краткого руководства представлена
на веб-сайте компании Tripp Lite по
адресу: www.tripplite.com/support
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
Copyright © 2019 Tripp Lite. All rights reserved.
Important Safety Instructions
SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be followed during the installation and use of all
Tripp Lite Wire Mesh Cable Tray systems. Failure to heed these warnings may affect your warranty.
• Installation should only be performed by a qualified installer and in accordance with all national and local electrical and
building codes.
• Always wear eye protection when cutting basket tray wire sections.
• Cut edges may be sharp. Exercise caution when handling trimmed basket tray during fabrication and installation.

2
Preparation and Fabrication
Wire Tray Models and Dimensions
Before proceeding with fabrication, first confirm your wire tray model and dimensions.
Model Sectional View Height Width Depth
SRWB6210STR 2 in. (50 mm) 6 in. (150 mm) 10 ft. (3000 mm)
SRWB12210STR 2 in. (50 mm) 12 in. (300 mm) 10 ft. (3000 mm)
SRWB6410STR
4 in. (100 mm) 6 in. (150 mm) 10 ft. (3000 mm)
SRWB12410STR
4 in. (100 mm) 12 in. (300 mm) 10 ft. (3000 mm)
SRWB18410STR
4 in. (100 mm) 18 in. (450 mm) 10 ft. (3000 mm)
How to Cut Wire Trays
Notes:
• Always use side-action bolt cutters.
• Angle all cuts away from the new end.
• Cut each wire with one clean cut whenever possible.
• Remove any sharp edges to eliminate possible damage to cables.
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
Cut the bottom wires first with the underside of the tray
facing up in the order as shown:
To cut the side wires, flip the wire tray over and cut in the
order shown, starting from the top:
Repeat as needed. For various wire cutting patterns and installation diagrams, refer to the documentation included with the
connectors and connector kits (sold separately).
19-04-073 93-3930_RevA
1
2
4
3
5
6
1
2
4
3
1
2
4
3