Tripp Lite SMART3000CRMXL User manual

Tripp Lite
1111 West 35th Street
Chicago, IL 60609 USA
Telephone: +[phone]
E-mail: [email protected]
Model #: SMART3000CRMXL
SmartPro 3kVA Line Interactive Sine Wave UPS, 2880 watts, Extended-run & SNMPWEBCARD options, 4U
Rack/Tower, Reduced-depth, USB, Serial, EPO, 120V
Highlights
3kVA / 3000VA / 2880W line interactive UPS; 0.96 power factor
120V nominal output with 83V to 145V input; Sine wave output
4U rack/tower with reduced depth; 2 post mounting kit included
USB, RS232, EPO and optional SNMP/Web card are available for
simultaneous use
Expandable runtime; 97% efficiency; 3 switched load banks
NEMA L5-30P / Hardwire input; 8 NEMA 5-15/20R & 1 L5-30R outlets
Description
Tripp Lites SmartPro Compact Rackmount Uninterruptible Power Supply (UPS) offers line interactive voltage regulation, network grade surge
suppression and long lasting battery support for critical network hardware during blackouts and extended power failures. Special reduced-depth
housing, larger internal batteries, higher rated wattage and included 2 post rackmount installation hardware makes these systems ideal for network
and telecom wiring closets and other limited-space installations. Runtime is expandable with optional BP48V48RT4U and BP48V24-2U
reduced-depth external battery packs.
SMART3000CRMXL 4U rackmount 3000VA UPS offers battery-derived sine wave AC output during power failures and extreme voltage variations.
Supports 3000VA/2880 watts when powered via included L5-30P input plug. Supports up to 3600VA/3600 watts when hardwired to a 120V 30A
input source. Line interactive Automatic Voltage Regulation (AVR) provides two levels of voltage boost during brownouts and one level of voltage cut
during overvoltage conditions to maintain regulated 120V nominal output over an input range of 83-145V. Includes NEMA L5-30P input plug (or
hardwire input), L5-30R and 5-15/20R output receptacles. Optional SNMPWEBCARD offers remote management and control of the UPS via direct
network connection. Additional ENVIROSENSE accessory, when used in conjunction with SNMPWEBCARD reports temperature, humidity and
status of up to two directly connected contact closure sensors. HID-compliant USB interface enables full integration with built-in power management
and auto shutdown features of Windows and Mac OS X. Supports detailed monitoring of equipment load levels, self-test data and utility power
conditions via all 3 network interfaces at once. Includes PowerAlert monitoring software with USB and serial cables. Emergency Power Off (EPO)
interface. Integrated 3-bank programmable PDU switching supports load shedding and remote-reboot of up to 3 individual connected devices.
3-stage metered current monitoring and battery charge status LEDs. Utility power and voltage regulation LEDs. Audible alarm. Self-test. 2-post
rackmount accessories included; 2-9USTAND tower stands and 4POSTRAILKIT 4 post rackmount kit available. Field-replaceable, hot-swappable
internal batteries and external battery packs. Attractive all-black color scheme.
Applications
Special reduced-depth housing, larger internal batteries, higher rated wattage and included 2 post rackmount installation hardware makes these
systems ideal for network and telecom wiring closets and other limited-space installations
Package Includes
SmartPro Compact 4U Rackmount UPS system
2 post rackmount installation brackets
USB and Serial Cabling
Owner's manual information
Features
Tripp Lite's SmartPro Compact Rackmount Uninterruptible Power Supply (UPS) offers line interactive voltage regulation, network grade
surge suppression and long lasting battery support for critical network hardware during blackouts and extended power failures
Special reduced-depth housing, larger internal batteries, higher rated wattage and included 2 post rackmount installation hardware makes
these systems ideal for network and telecom wiring closets and other limited-space installations
Runtime is expandable with optional BP48V48RT4U and BP48V24-2U reduced-depth external battery packs
Some external battery configurations require the use of Tripp Lite's External Battery Configuration Software (see manual)

Some external battery configurations require the use of Tripp Lite's External Battery Configuration Software (see manual)
SMART3000CRMXL 4U rackmount 3000VA/2880 watt UPS offers battery-derived sine wave AC output during power failures and extreme
voltage variations
Supports loading up to 3600 watts when hardwired
Line interactive Automatic Voltage Regulation (AVR) provides two levels of voltage boost during brownouts and one level of voltage cut
during overvoltage conditions to maintain regulated 120V nominal output over an input range of 83-145V
Includes NEMA L5-30P input plug (hardwire line cord installation supported), L5-30R and 5-15/20R output receptacles
Network management interfaces support simultaneous communications via USB port, DB9 serial port and optional SNMP/Web
management accessory card slot
Optional SNMPWEBCARD offers remote management and control of the UPS via direct network connection
Additional ENVIROSENSE accessory, when used in conjunction with SNMPWEBCARD reports temperature, humidity and status of up to
two directly connected contact closure sensors
HID-compliant USB interface enables full integration with built-in power management and auto shutdown features of Windows and Mac OS
X
97% efficiency in line power mode offers substantially lower operating costs than lower efficiency UPS types
Supports detailed monitoring of equipment load levels, self-test data and utility power conditions via all 3 network interfaces at once
Includes PowerAlert monitoring software with USB and serial cables
Emergency Power Off (EPO) interface
Integrated 3-bank programmable PDU switching supports load shedding and remote-reboot of up to 3 individual connected devices
3-stage metered current monitoring and battery charge status LEDs; Utility power and voltage regulation LEDs; Audible alarm; Self-test
2-post rackmount accessories included; 2-9USTAND tower stands and 4POSTRAILKIT 4 post rackmount kit available
Field-replaceable, hot-swappable internal batteries and external battery packs
Attractive all-black color scheme
Specifications
OUTPUT
Output Volt Amp
Capacity (VA)
3000
Output Watt Capacity
(watts)
2880
Output Capacity
Details
Supports 3600 watts max with hardwire input
Nominal Output
Voltage(s) Supported
120V
Frequency
compatibility
60 Hz
Output voltage
regulation (line mode)
-18%, +8%
Built-in UPS output
receptacles
8 5-15/20R outlet(s); 1 L5-30R outlet(s)
Built-in controllable
switched load banks
Three switchable single-outlet 5-15/20R load banks
Output circuit breaker 20A (x2) - each 20A breaker protects 4 5-15/20R outlets / 30A breaker protects L5-30R
INPUT
Rated input current (at
maximum load)
24A (L5-30P input), 30A (hardwire)
Nominal Input
Voltage(s) Supported
120V AC
UPS input connection
type
L5-30P; Hardwire

UPS Input cord length
(ft.)
10 ft.
UPS Input cord length
(m)
3.05
Recommended
Electrical Service
120V 30A
Voltage compatibility
(VAC)
120
BATTERY
Full load runtime
(minutes)
7.5 min. (2880w)
Half load runtime
(minutes)
19 min. (1440w)
External battery pack
compatibility
BP48V24-2U (limit 1); BP48V48RT4U (multi-pack compatible)
DC system voltage
(VDC)
48
Battery recharge rate
(included batteries)
Less than 7.2 hours from 10% to 90%
Replacement battery
cartridge (internal
UPS battery
replacement)
RBC54 (quantity 2)
Battery Access Battery access door allows hot swap battery replacement without powering connected equipment off
VOLTAGE REGULATION
Voltage regulation
description
Automatic Voltage Regulation (AVR) circuits maintain clean, regulated computer-grade 120V nominal output,
without using battery power, during brownouts to 83V and overvoltages to 145V
Overvoltage correction Input voltages between 127 and 145V AC are reduced by 12%
Undervoltage
correction
Input voltages between 96 and 108 are boosted by 12%
Severe undervoltage
correction
Input voltages between 83 and 95 are boosted by 24%
LEDS ALARMS & SWITCHES
LED Indicators 5 LEDs indicate line power, battery power, overload, voltage regulation and battery low/replace status
Alarms 3 function audible alarm indicates power failure conditions (4 short beeps every 10 seconds), overload (continuous
short beeps) and low battery (continuous tone)
Switches Yes, includes 2 front panel mounted push-button switches for system enable, self-test and alarm cancel functions.
Back panel includes battery charge level switch for internal or external battery configurations
SURGE / NOISE SUPPRESSION
UPS AC suppression
joule rating
570 joules
EMI / RFI AC noise
suppression
Yes
AC suppression
response time
Instantaneous
PHYSICAL

Installation form
factors supported with
included accessories
2 post 19 inch rackmount (mounting rail kit included)
Installation form
factors supported with
optional accessories
4 post rackmount (4POSTRAILKIT); Tower (2-9USTAND)
Primary form factor Rackmount
UPS / Power Module
dimensions in primary
form factor (height x
width x depth / inches)
7 x 17.3 x 16.8
UPS / Power Module
dimensions in primary
form factor (height x
width x depth / cm)
17.8 x 43.9 x 42.7
Installed whole
system total rack
space height (rack
spaces)
4U
UPS / Power Module
weight (lbs)
102
UPS / Power Module
weight (kg)
46.3
UPS Shipping
dimensions (height x
width x depth / inches)
13.2 x 23.6 x 22.8
UPS Shipping
dimensions (height x
width x depth / cm)
33.5 x 59.9 x 57.9
Shipping weight (lbs) 124
Shipping weight (kg) 56.3
UPS housing material Steel
Cooling method Fan
ENVIRONMENTAL
Operating
Temperature Range
+32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius
Storage Temperature
Range
+5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius
Relative Humidity 0-95%, non-condensing
AC mode BTU / hr.
(full load)
408
Battery mode BTU /
hr. (full load)
2149.5
COMMUNICATIONS
Communications
interface
USB (HID enabled); DB9 Serial; EPO (emergency power off); Slot for SNMP/Web interface
WatchDog
compatibility
Yes, compatible with Tripp Lite's Watchdog system service to restore operation to locked equipment through soft
reboot of application / OS or hard power off/on reboot of connected equipment ideal for unattended kiosk
applications

EPO port Includes RJ11 EPO (emergency power off) port and interconnection cable
SNMP compatibility Yes, includes slot for optional SNMPWEBCARD accessory (#SNMPWEBCARD)
Software and cabling
included
Yes, includes PowerAlert software CD-ROM and complete cabling
LINE / BATTERY TRANSFER
Transfer time 5 ms. (typical)
Low voltage transfer
to battery power
(setpoint)
83
High voltage transfer
to battery power
(setpoint)
145
SPECIAL FEATURES
Cold Start (startup in
battery mode during a
power failure)
Cold-start operation supported
Appearance Attractive black rackmount housing, optional use 2U black front bezel included to enable black color appearance
CERTIFICATIONS
Certifications Tested to UL1778 (USA), CSA (Canada), NOM (Mexico), Class A (Emissions)
WARRANTY
Product Warranty
Period (Worldwide)
2-year warranty, 3 year with registration. Note: registration is required for 3-year warranty.
Connected Equipment
Insurance (U.S.,
Canada & Puerto Rico)
$250,000 Ultimate Lifetime Insurance
Related Items
Optional Products
Product Type Related Model Description Qty.
External Battery Packs BP48V24-2U BP48V242U - External Battery Pack for UPS System 1
External Battery Packs BP48V48RT4U Shallow-Depth External Battery Pack For UPS Systems 1
Power Distribution PDU2430 Basic PDU / Power Distribution Unit - Safe, reliable power distribution
for critical networking equipment
1
Power Distribution PDUMH30NET Switched, Metered PDU with Remote Monitoring - 2U Rackmount
Power Distribution Unit for Networks with Individually Switchable
Outlets, Current Metering, Remote Monitoring and Control
1
Power Distribution PDUMV30 Metered 0U Vertical Rack PDU - Metered Power Distribution Unit for
Network Applications
1
Power Distribution PDUMV30NET Switched, Metered PDU with Remote Monitoring - 0U Vertical
Rackmount Power Distribution Unit for Networks with Individually
Switchable Outlets, Current Metering, Remote Monitoring and Control
1
Rackmount/Wallmount Kits 4POSTRAILKIT Enables 4-Post Rackmount Installation of Select Rackmount UPS
Systems
1
SNMP Accessories ENVIROSENSE Monitors temperature, humidity and contact-closure inputs. (Requires
SNMPWEBCARD or switched PDU.)
1
SNMP Accessories SNMPWEBCARD For remote monitoring and control via SNMP, Web, or Telnet. 1
Start-Up/Warranty
Services
WEXT5-2200-3000 5-Year Extended Warranty - For Smart Line-Interactive and Online
Tower or Rack models, 2200-3000VA or less
1

Tower Stands 2-9USTAND Enables Tower Placement of Rackmount UPS Systems 1
More information, including related products, owner's manuals, and additional technical specifications, can be found online at
www.tripplite.com/en/products/model.cfm?txtModelID=3824.
Copyright © 2012 Tripp Lite. All rights reserved. All trademarks are the sole property of their respective owners. Tripp Lite has a policy of continuous
improvement. Specifications are subject to change without notice. Photos may differ slightly from final products.