Triton TDM 100 User manual

TDM 100 Packaging Instrucons
TDN 07103-00253 February 16, 2015
Corporate Headquarters:
21405 B Street
Long Beach, MS 39560
Phone: [phone]
Fax: [phone]
COPYRIGHT NOTICE
© 2015 Triton. All Rights Reserved. TRITON logo is a registered trademark of
Triton Systems of Delaware, LLC

TDM 100 PACKAGING INSTRUCTIONS
2
Introducon
This document describes how to package a TDM 100 Dispenser.
Tools Required
Packaging tape
Bubble wrap
KIT P/N:
06300-01100 TDM 100 Packaging Kit
PARTS SUPPLIED IN KIT
Descripon Quanty
Carton|TDM C and D|18 inches X 18 inches X 15 inches 1
Cassee Carton: 16 inches X 12 inches X 8 inches 1
Foam|Foam for TRI-E & D 1
Pad w/Foam|TDM Top Pad w/Foam (plain) 1
Insert, Foam Block 1
Foam Block
Top Pad w/Foam
Dispenser Carton
(18inX18inX15in)
Boom Foam
Cassee Carton
(16in X 12in X 8in)

TDM 100 PACKAGING INSTRUCTIONS
3
1. Assemble both the dispenser carton and
the cassee carton by folding the small
aps in and the long aps over them
with the part numbers facing out. Seal
with tape. (Figure 1)
Figure 1
2. Remove the cassee and reject bin from
the dispenser. (Figure 2)
If the keys are being shipped, remove them
and tape to the to the top of the cassee.
Do the same for the reject bin.
Figure 3
Figure 2
3. Wrap both cassee and reject bin in
bubble wrap. (Figure 3)
Cassee
Reject

TDM 100 PACKAGING INSTRUCTIONS
4
Figure 4
4. Line the cassee carton with bubble wrap.
Place the cassee and reject bin inside. (Figure
4) Fill in extra space with bubble wrap.
5. Close the carton and seal with tape. (Figure
5)
Figure 5
6. Place the boom foam in the dispenser
carton with the small notch in the back right
corner. (Figure 6)
Figure 6

TDM 100 PACKAGING INSTRUCTIONS
5
Foam block
Figure 8
8. Insert the foam block in front of the
dispenser. (Figure 8)
7. Place the dispenser into the foam boom
with the belt cover ng into the small notch.
(Figure 7)
Belt cover
Figure 7
Figure 9
Motor
9. Set the top foam in the dispenser carton so
the motor ts into the small notch. The motor
will be at the top right side of the dispenser.
(Figure 9)

TDM 100 PACKAGING INSTRUCTIONS
6
Figure 10
10. Lower the top foam down so it ts snug
around the top of the dispenser. (Figure 10)
11. Close the dispenser carton and seal with
tape. (Figure 11)
Figure 11
11. Close the dispenser carton and seal with
tape. (Figure 12)
Figure 12