TRIWA NEVIL User manual

NEVIL INSTRUCTIONS
SETTING TIME AND DATE
Setting the TIME:
1. Release crown by screwing counter-clockwise
2. Pull out the crown
3. Set the time by screwing the crown
4. When time is set, push the crown back and fix it by screwing clockwise
RESET Chronograph hands:
1. Release crown by screwing counter-clockwise
2. Pull out the crown
3. Push A to reset the hands position to zero. Continue to push A to put them forward.
4. When set, push the crown all the way back down and secure by screwing clockwise
Home /NEVIL INSTRUCTIONS

CHANGE STRAP
1. Using the TRIWA strap tool, place the strap changing end between the lug and the strap to reach the metal pin
2. Push down to release the spring and remove the strap
3. Move the pins from the old to the new strap
4. Place the pin end to the lug hole
5. Use the tool again to push down the spring so that the pin end reaches the hole for fastening
ATTACHING NATO/MONO STRAP
1. Unless the watch has fixed lugs, use the TRIWA strap tool to remove the existing strap (see 'CHANGE STRAP'
instructions)

2. Attach the pins to the watch case again but without strap
3. Attach the long strap part as seen in image A
4. Secure the watch case by letting the long strap part through the loop of the shorter part as seen in image B
ADJUSTING MESH STRAP SIZE
1. Use the TRIWA strap tool to lift up the locking part as seen in image A
2. Slide the buckle along the strap to adjust the size as seen in image B. Note that the strap has cavities on the
backside for different buckle options
3. When correct size is set, push down the locking part as seen in image C
ADJUSTING BUTTERFLY STRAP SIZE
adjusting strap” src=
1. Push buckle buttons to open the strap as seen in image A
2. Flip open the hinged metal part to move the pin to a different strap hole for size adjustment as seen in image B
3. When the correct time is set, push the metal part back down
The TRIWA brand and logo are registered trademarks of TRIWA AB.