Troglotech T804 WiFi System User manual

Troglotech T804 Initial Use Guide DISTRIBUTOR INFO Page 1
INITIAL USE GUIDE — T804 SYSTEM
Troglotech td Phone [phone]
Unit 1, 3 Penns Road Phone [phone]
Petersfield Fax [phone]
Hampshire Email [e-mail]
GU32 2EW Web www.troglotech.com
DISTRIBUTOR INFORMATION

Troglotech T804 Initial Use Guide DISTRIBUTOR INFO Page 2
2) Cut the tie-wraps. Disconnect the
Keyboard connector
QUICK START GUIDE
3) Remove Control Unit from frame 4) Remove Keyboard from frame
5) Fit Keyboard to top frame 6) Fit Control Unit to top frame. It is
easier to fit one clip at a time
1) The T804 is delivered with the Con-
trol Unit and Keyboard fitted as above
and secured with tie-wraps

Troglotech T804 Initial Use Guide DISTRIBUTOR INFO Page 3
QUICK START GUIDE
7) Connect Keyboard connector to
the Control Unit
8) Connect ink Cable to Control
Unit
10) Adjust the brake lever so that the
coiler can be turned with a little resis-
tance
11) Cut tie-wrap and remove soft
cover from termination. Thread the
termination through the Rod Guide
12) Fit the T800 camera to the
termination. Fit skid set (see manual
for full instructions)
9) Fit two of the cable clips as shown
to secure the ink Cable. There are 4
clips supplied with the system.

Troglotech T804 Initial Use Guide DISTRIBUTOR INFO Page 4
14) Remove CF card cover by pulling
UP and then BACK on the hawser
QUICK START GUIDE
15) Fit CF card and replace cover 16) Remove the protective film from
the Control Unit CD
17) Switch T804 ON 18) System is ready to use - please
see T804 Operating Instructions
13) Tighten brake to ensure coiler is
secure