
EN3convector TCH 1 E•Only put up the device in an upright, stable position on firmground.•Let the device dry out after a wet clean. Do not operate itwhen wet.•Do not use the device with wet or damp hands.•Do not expose the device to directly squirting water.•Never insert any objects or limbs into the device.•Do not cover or transport the device during operation.•Do not remove any safety signs, stickers or labels from thedevice. Keep all safety signs, stickers and labels in legiblecondition.•Do not sit on the device.•This appliance is not a toy! Keep away from children andanimals. Do not leave the device unattended duringoperation.•Check accessories and connection parts for possibledamage prior to every use of the device. Do not use anydefective devices or device parts.•Ensure that all electric cables outside of the device areprotected from damage (e.g. caused by animals). Neveruse the device if electric cables or the power connectionare damaged!•The mains connection must correspond to thespecifications in the Technical annex.•Insert the mains plug into a properly secured mainssocket.•Observe the device's power input, cable length andintended use when selecting extensions to the powercable. Completely unroll extension cables. Avoid electricaloverload.•Before carrying out maintenance, care or repair work onthe device, remove the mains plug from the mains socket.Hold onto the mains plug while doing so.•Switch the device off and disconnect the power cable fromthe mains socket when the device is not in use.•Do not under any circumstances use the device if youdetect damages on the mains plug or power cable. If the power cable is damaged, it must be replaced by themanufacturer, its service agent or similarly qualifiedpersons in order to avoid a hazard.Defective power cables pose a serious health risk!•During the installation of the device observe the minimumdistances from walls and other objects as well as thestorage and operating conditions specified in the Technicaldata chapter.•Do not use the device in immediate proximity to curtains,beds or sofas.•Make sure that the air inlet and outlet are not obstructed.•Make sure that the suction side is kept free of dirt andloose objects.•Do not place the device on combustible ground.•Only use original spare parts, for otherwise safe andfunctional operation cannot be ensured.•Allow the device to cool down before transport and/ormaintenance work.•Do not use this device near bathtubs, shower trays,swimming pools or other water containers. Risk of electricshock!•The device must not be positioned directly beneath a wallsocket.•The device must be set up in a way that the switches andcontrollers cannot be touched by a person in a bathtub orshower.•Do not use the device any more once it has been dropped.Intended useThe device is only suitable for well insulated spaces oroccasional use.Only use the device for heating closed rooms whilst adhering tothe technical data.Intended use comprises heating the air in:•living spaces•storerooms•salesrooms•construction areas•containers•basementsForeseeable misuse•Do not place the device on wet or flooded ground.•Do not place any objects, e.g. clothing, on the device.•Do not use this device in the vicinity of fuel, solvents,varnishes or other easily inflammable vapours or in roomswhere these substances are stored.•Do not use the device outdoors.•Do not use the device for heating vehicles.•The device must not be mounted to and operated on awall.•The device must not be used near swimming pools.•Do not use this device in the immediate vicinity of sinks,bathtubs or other water containers.Never immerse the device in water.•Any use other than the intended use is regarded as areasonably foreseeable misuse.•Do not make any unauthorised modifications, alterations orstructural changes to the device.