Trotec BY10 User manual

TRT-BA-BY10-TC2017-43-003-EN
BY10
EN
OPERATING MANUAL
TYRE PRESSURE GAUGE

2 EN
tyre pressure gauge BY10
Table of contents
Notes regarding the operating manual.................................2
Safety .....................................................................................2
Information about the device................................................3
Transport and storage...........................................................4
Operation ...............................................................................4
Maintenance and repair ........................................................5
Errors and faults....................................................................5
Disposal .................................................................................5
Notes regarding the operating manual
Symbols
Warning of electrical voltage
This symbol indicates dangers to the life and health of
persons due to electrical voltage.
Warning
This signal word indicates a hazard with an average
risk level which, if not avoided, can result in serious
injury or death.
Caution
This signal word indicates a hazard with a low risk
level which, if not avoided, can result in minor or
moderate injury.
Note
This signal word indicates important information (e.g.
material damage), but does not indicate hazards.
Info
Information marked with this symbol helps you to carry
out your tasks quickly and safely.
Follow the manual
Information marked with this symbol indicates that the
operating manual must be observed.
You can download the current version of the operating manual
and the EU declaration of conformity via the following link:
BY10
https://hub.trotec.com/?id=41249
Safety
Read this manual carefully before starting or using the
device. Always store the manual in the immediate vicinity
of the device or its site of use.
Warning
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may
result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
This appliance can be used by children aged from
8years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe
way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children
without supervision.
• Do not use the device in potentially explosive rooms or
areas and do not install it there.
• Do not use the device in aggressive atmosphere.
• Do not immerse the device in water. Do not allow liquids to
penetrate into the device.
• The device may only be used in dry surroundings and must
not be used in the rain or at a relative humidity exceeding
the operating conditions.
• Protect the device from permanent direct sunlight.
• Do not remove any safety signs, stickers or labels from the
device. Keep all safety signs, stickers and labels in legible
condition.
• Do not open the device.
• Observe the storage and operating conditions as given in
the Technical data chapter.

EN 3
tyre pressure gauge BY10
Intended use
Only use the device to measure the tyre pressure on Schrader
valves, as they are used on car and motorbike tyres and
sometimes on bicycle tyres. Make sure to adhere to the
measuring range specified in the technical data.
To use the device for its intended use, only use accessories and
spare parts which have been approved by Trotec.
Improper use
Do not use the device in potentially explosive atmospheres, for
measurements in liquids or at live parts. Trotec accepts no
liability for damages resulting from improper use. In such a
case, any warranty claims will be voided. Any unauthorised
modifications, alterations or structural changes to the device are
forbidden.
Personnel qualifications
People who use this device must:
• have read and understood the operating manual, especially
the Safety chapter.
Residual risks
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
Warning
The device is not a toy and does not belong in the
hands of children.
Warning
Dangers can occur at the device when it is used by
untrained people in an unprofessional or improper way!
Observe the personnel qualifications!
Caution
Keep a sufficient distance from heat sources.
Note
To prevent damages to the device, do not expose it to
extreme temperatures, extreme humidity or moisture.
Note
Do not use abrasive cleaners or solvents to clean the
device.
Information about the device
Device description
With this device you can determine the tyre pressure with digital
precision and read it on the LCdisplay.
The device is equipped with an integrated LEDtorch allowing
you to determine the pressure or condition of the tyre in the
dark.
Device depiction
5
6
4
1
2
3
No. Designation
1 Function button
2 LCD display
3 LED torch
4 Cover of the battery compartment
5 Screw, battery compartment cover
6 Measuring tip
Display
10
7
9
8
No. Designation
7 Indication of the unit: psi
8 Indication of the unit: bar
9 Indication of the unit: kPa
10 Measurement value display

4 EN
tyre pressure gauge BY10
Technical data
Parameter Value
Model BY10
Measuring range 5 to 100psi
0.35 to 6.9bar
35 to 690kPa
Accuracy ±1% / 0.5psi
±1% / 0.05bar
±1% / 3.5kPa
Ambient conditions 0°C to 50°C (35°F to 122°F) with
<80%RH
Power supply 2x 1.5V AAAbatteries
Automatic switch-off after approx. 45 seconds
Dimensions (lengthx
widthx height)
156 x 20 x 42mm
Weight 82g
Scope of delivery
• 1 x Tyre pressure gauge
• 2x 1.5V battery AAA
• 1x Quick guide
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
The manufacturer packed the device to the best of his abilities
to protect it against transport damage.
When transporting the device, ensure dry conditions and and
protect the device from external influences e.g. by using a
suitable bag.
Storage
When the device is not being used, observe the following
storage conditions:
• dry and protected from frost and heat
• protected from dust and direct sunlight
• The storage temperature is the same as the range given in
the Technical data chapter.
• Remove the batteries from the device.
Operation
Inserting the batteries
Note
Make sure that the surface of the device is dry and the
device is switched off.
Info
The battery tab(11) must be removed before initial
use.
The battery must be changed if the indication on the LCdisplay
is only faintly visible during start-up.
1. Use a screwdriver and carefully remove the screw(5) at
the rear of the device.
2. Remove the battery compartment cover(4).
3. Insert the batteries(2batteries of typeAAA) into the
battery compartment with correct polarity.
4. Put the cover back onto the battery compartment(5).
5. Use a screwdriver to carefully tighten the screw(5).
4
5
11
Switch-on and air pressure measurements
Info
The tyres should be cold for measurement! Warm tyres
can distort the measurement result.
1. Briefly press the function button(1) to switch the device
on.
ðThe LCdisplay(2) is switched on and shows you the
last measuring unit used.
ðThe LEDtorch(3) turns on.
2. Place the measuring tip(6) on the valve of your tyre. The
LCdisplay(2) now shows the tyre pressure in the
previously selected measuring unit.
6
2

EN 5
tyre pressure gauge BY10
Changing the unit psi/ bar/ kPa
Press the function button(1) again to switch between the units
(psi- bar- kPa).
Automatic switch-off
If the device is not used for 45seconds, it switches off
automatically.
Switch-off
If you want to switch off the device directly, press and hold the
function button(1) for approx.3seconds until the device is
switched off.
Maintenance and repair
Cleaning
Clean the device with a soft, damp and lint-free cloth. Make
sure that no moisture enters the housing. Do not use any
sprays, solvents, alcohol-based cleaning agents or abrasive
cleaners, but only clean water to moisten the cloth.
Repair
Do not modify the device or install any spare parts. For repairs
or device testing, contact the manufacturer.
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Display segments are only faintly visible or the display
lamp is only dimly lit:
• The battery power is too low, the battery must be changed
The LEDtorch is only dimly lit or remains off
• The battery power is too low, the battery must be changed
Disposal
The icon with the crossed-out waste bin on waste
electrical or electronic equipment stipulates that this equipment
must not be disposed of with the household waste at the end of
its life. You will find collection points for free return of waste
electrical and electronic equipment in your vicinity. The
addresses can be obtained from your municipality or local
administration. For further return options provided by us please
refer to our website https://de.trotec.com/shop/.
The separate collection of waste electrical and electronic
equipment aims to enable the re-use, recycling and other forms
of recovery of waste equipment as well as to prevent negative
effects for the environment and human health caused by the
disposal of hazardous substances potentially contained in the
equipment.
In the European Union, batteries and accumulators must not be
treated as domestic waste, but must be disposed of
professionally in accordance with Directive 2006/66/EC of the
European Parliament and of the Council of 6September 2006
on batteries and accumulators. Please dispose of batteries and
accumulators according to the relevant legal requirements.

Trotec GmbH
Grebbener Str. 7
D-52525 Heinsberg
+49 2452 962-400
+49 2452 962-200
www.trotec.com
Other manuals for BY10
2
Table of contents
Other Trotec Measuring Instrument manuals

Trotec
Trotec TA 300 User manual

Trotec
Trotec BN35R User manual

Trotec
Trotec BE20 User manual

Trotec
Trotec BS30WP User manual

Trotec
Trotec T3000 User manual

Trotec
Trotec TD120 User manual

Trotec
Trotec BD11 User manual

Trotec
Trotec BM18 User manual

Trotec
Trotec BM31 User manual

Trotec
Trotec SL800-SET User manual
Popular Measuring Instrument manuals by other brands

ITRON
ITRON RF1 instruction manual

SGL
SGL TurfPod instruction manual

Greyline Instruments
Greyline Instruments SFM 6.1 Installation & operation instructions

Thornwave Labs
Thornwave Labs PowerMon-5S user manual

Endress+Hauser
Endress+Hauser FOUNDATION Proline 500 digital Brief operating instructions

TPI
TPI 1008 manual