TRU Audio HS-SUB-12 User manual

Hardscape Subwoofer
User Manual
HS-SUB-12
TruAudio’s Hardscape subwoofer, HS-SUB-12, is
designed to be water tight with a minimal footprint. It can
be strategically installed in almost any space, delivering
powerful bass. The Hardscape sub can be wired 4Ωor
70v, making it as versatile as it is powerful.
Contents:
• Hardscape subwoofer
• (2) Silicone filled wire nuts
• (4) Rubber feet
Subwoofer Placement
The Hardscape subwoofer provides low frequency bass
covering up to 2500 sq. feet or about a 30’ radius.
Whenever possible try to locate it in the middle of the
listening area. The included rubber feet gives you the
flexibilty to place it in many locations by helping level and
stabilize the sub on uneven surfaces.
70V Installation Basics
When installing the sub as 70v, make sure the total tap
setting wattage does NOT exceed 80% of the amp’s rated
power.
Finding the Correct Amp Size
AMP POWER x 80% = SAFE
1000W x 80% = 800W
800W ÷ 200W = 4 Subwoofers
Summary: If using a 1000 watt per channel amplifier like
the CDi 4000, you can use (4) 200W Hardscape
subwoofers (HS-SUB-12).
Description
Wiring the Hardscape Sub 70v
Connect the red cable (70V+ input) and black cable (70V-
input) to the amp. Leave the green cable (70V+ output)
connected with the yellow cable (4Ω+ input) and the white
(70V- output) connected with the blue (4Ω- input) cable.
CROWN AMPLIFIER
To 70V Speakers
70V+ INPUT
70V- INPUT
70V- OUTPUT
4Ω- INPUT
4Ω+ INPUT
70V+ OUTPUT
70v AMPLIFIER
RED +
TAP SETTING 200W + + +
=
200W 200W 200W
= 800W or 80% of the Amp’s Power
BLACK -
All manuals and user guides at all-guides.com
all-guides.com

It is the policy of TRUAUDIO to continuously incorporate improvements into our products. All specifications are
subject to change without notice. If you have any questions regarding this or any other TRUAUDIO products,
please visit www.TruAudio.com or contact us:
Office: 1-888-858-1555, Monday-Friday 7 am - 6 pm MST.
Email: [email protected]
TruAudio
198 N Old Highway 91
Hurricane, UT 84737 USA
Specifications
HS-SUB-12
Speaker Type:
Woofer:
Impedance:
Power (4Ω):
Power (70V):
Frequency Response:
Sensitivity:
Cabinet Dimensions:
Outdoor Hardscape subwoofer
12” injected polypropylene
4Ω or 70V
250W
200W
28 - 150 Hz (+/- 3dB)
90dB
15.6” (396mm) W,
15.6” (396mm) D,
16.5” (420mm) H,
SoundVision Technologies dba
OUTDOOR SPEAKERS and SUBWOOFERS PRODUCT WARRANTY
All outdoor speakers and subwoofers have a limited 5 year warranty. This warranty includes lifetime parts and repair
labor on all components. The warranty extends only to the original purchaser of the product and not to any
subsequent owner. TRUAUDIO’s obligation under these warranties is limited to repairing or replacing any
component found defective in material or workmanship under normal conditions of use with an equal and/or current
product. These warranties shall not apply to products which have been abused, modified, or disassembled.
Products to be repaired or returned under this warranty must be returned to the factory through an authorized
TruAudio dealer with all transportation and insurance charges prepaid.
Wiring the Hardscape Sub 4Ω:
Cut the blue/white and yellow/green wires. Connect the
yellow (4Ω+ input) wire & the blue (4Ω- input) wire to the
positive and negative output from the 4Ωamp.
4Ω- INPUT
4Ω+ INPUT
4Ω
4 OHM AMPLIFIER
To 70V Speakers
All manuals and user guides at all-guides.com