TrueDio® Ears User Manual
9
STEP 3 - Charge Headset Prior to Use
Verify that all plugs are securely in place and that the transmitter is located
within range. Next, turn and power on your transmitter by sliding power
switch on the back of the transmitter to the Mono or Stereo position. The
green power indicator will light up confirming power is on. Next, firmly
place your headset in the transmitter charging dock for 3-5 hours to fully
charge the battery prior to use. (See Transmitter Charging Base Lights
section for more information)
STEP 4 –Power On and Use Headset
Power on your headset by sliding the power switch to the “ON”
position. The blue power indicator will light up confirming power is on. A
solid blue light confirms that the headset is receiving an audio signal from
the transmitter. The blue light will blink if the headset is not receiving an
audio signal, in which you should verify that your audio source and
TrueDio Ears are turned to the ON position, and all connections are
securely in place.
You are now ready to use your TrueDio® Ears! Simply adjust the volume
and tone to your preferred levels and enjoy!
STEP 5 –Power Off Headset
Power off your headset by sliding the power switch to the “OFF” position.
The blue power indicator light will turn off confirming the power is off. In
the event that you forget to power off your headset, the headset will
automatically power off after 3 minutes of audio inactivity to conserve
battery life. Once the headset turns off after inactivity, it will NOT turn
back on automatically. Power off your headset completely then turn it back
ON.
