6 7
Temperature settings – sends a notication to your smartphone when the upper and lower
temperature limits you set are detected
Note: To see motion, sound and temperature detection notications, make sure you have enabled app
notications in your phone settings.
Playback recording from microSD card – in addition to your phone gallery, you can also save
recordings to a microSD card
Note: When the camera is o, insert the card (see Product Layout – Camera (baby unit) section) and for-
mat the card under settings before recording. In the settings, you can also choose whether the camera will
record to the card constantly or only when motion is detected.
SECURITY AGAINST HACKING
The app uses ve-layer security technology to ensure the security of smart devices without the risk
of information being compromised: military-grade AES data encryption, triple-check authorization
and authentication, two-code dynamic key, and HTTPS channel encryption guarantee the security of
network trac.
Note: To increase protection against hacking, set the strongest possible password on your Wi-Fi network.
The password should consist of at least eight characters with a combination of uppercase and lowercase
letters and numbers. Do not use special characters „~!@#$%^*-“, otherwise the camera will not be able
to pair.
Transmission between the camera and the parent unit is carried out wirelessly via the encrypted WiFi
standard 802.11ah sub-1 GHz.
RANGE
− The maximum range of the baby monitor is 300 m in an open area and 50 m in a building.
−The maximum range of the baby monitor and signal transmission can be aected by the envi-
ronment in which you use the baby monitor, such as thick walls, reinforced concrete structures,
etc.
−If the connection is lost due to being too far away from the baby unit, the parent unit will indicate
this on the display with a red disconnected icon.
TROUBLESHOOTING
Problem Solution
The camera does not pair with the smartphone
app.
Check if the camera is connecting to the correct
WiFi network. The camera only supports 2.4 GHz.
The Wi-Fi password must not contain special
characters: ~!@#$%^*-.
The camera is not transmitting the image to
the parent unit.
The camera is already paired with the parent
unit out of the box. However, if you can‘t see any
image, unpair the camera in the settings menu
and re-pair with the parent unit (see PAIRING THE
CAMERA TO THE PARENT UNIT section).
The image is frozen and the parent unit is not
responding.
Reset the parent unit using the included reset pin.
