Tuuci bay master MAX center post Quick reference guide

INSA4000 4.12.17
bay master MAX center post
assembly & operating instructions
2013 LOGO & COLOR GUIDELINES
FOILS / PMS 1&2 COLOR
GLOSS FOIL
PMS 1795 C
877 DULL FOIL
PMS 1795 C
GLOSS FOIL
877 DULL FOIL
PMS 1&2 COLOR
PMS 877 C
PMS 1795 C
PMS 877 C
PMS 1795 C
BLACK & WHITE 1 COLOR
BLACK
WHITE
to protect your product,
read operating instructions before opening parasol

2
|tuuci
INSA4000 4.12.17
ASSEMBLY & OPERATING INSTRUCTIONS BAY MASTER MAX Center Post
octagon
square
applies to:
Step 1
Remove all packaging from umbrella, including inside the umbrella.
Step 2
Remove deck mount from mast and install
it in selected mounting base
Step 3
Once deck mount is installed, place the
umbrella in and tighten star-knob.
Make sure lock spring pin is in base slot
to secure umbrella in place.

tuuci
| 3
INSA4000 4.12.17
ASSEMBLY & OPERATING INSTRUCTIONS BAY MASTER MAX Center Post
POSITIONING UNBRELLA FRAME
Step 5
Gently slide main hub handle up center
post until clip bracket engages to slot.
Step 4
Gently separate each rib individually from
center post, approximately 10 inches.

4
|tuuci
INSA4000 4.12.17
ASSEMBLY & OPERATING INSTRUCTIONS BAY MASTER MAX Center Post
DO NOT OPERATE
WITHOUT CONNECTING
RIB STRUTS TO HUB
WITH COTTER PINS
Note:
You may need to use a
tool to help align the holes.
Step 6
Connecting rib struts to hub with cotter pins

tuuci
| 5
INSA4000 4.12.17
ASSEMBLY & OPERATING INSTRUCTIONS BAY MASTER MAX Center Post
Note:
You may need to use a
tool to help align the holes.
Image for illustration only
a/c plug not included.
IF APPLICABLE - LIGHT ACCESSORIES
Step 7
Connect electrical extention cable Step 8
Per job application connect required a/c plug
to the free ends of power supply.
Step 9
Use touch sensor detector to control light
brightness from low to high

6
|tuuci
INSA4000 4.12.17
ASSEMBLY & OPERATING INSTRUCTIONS BAY MASTER MAX Center Post
Note: close umbrella during wind conditions that exceed manufacturer’s specications.
Step 10
To close umbrella, press down clip bracket
to disengage from slot then slide down
gently.

tuuci
| 7
INSA4000 4.12.17
ASSEMBLY & OPERATING INSTRUCTIONS CARE & MAINTENANCE
TUUCI frames are constructed from durable, marine-grade, weather resistant materials including: fiberglass,
armor-wall aluminum, Dura-TEAK composites, Aluma-TEAK aluminum and sustainable hardwood. All fasten-
ers (nuts, bolts, pulleys, cam cleats, etc.) are marine-grade stainless steel and will withstand the most corrosive
environments. Proper care and maintenance is important to extend the serviceable life of all TUUCI products.
We recommend the following:
• Fresh water rinses once a week
• Weekly inspection of your TUUCI product is recommended. Loose screws should be tightened and any
broken components replaced immediately to avoid further damage to your product.
• Prior to opening, ensure that the shade product is properly secured to an adequate shade anchor system.
• When opening a TUUCI parasol, separate each rib 10 inches from the center post, before raising the hub.
Do not force hub if it does not rise easily.
• When closing the parasol, pull the fabric out from between the struts to avoid pinching or damaging the
TUFF-SKIN canopy membrane.
• TUUCI recommends that all collapsible shade equipment be closed in wind conditions which exceed 25 MPH.
• Clean above ground parasol bases regularly to maintain appearance. To clean, gently wash with soap and
water using a nonabrasive cloth or pad.
• Check bolts in security stem regularly to ensure that they remain fully tightened.
• Do not roll Aluma-crete (Aluminum Shell, Concrete Filled) bases on their side as damage to shell
or nish can occur.
• Do not use on stairways or over distances which exceed 50 feet, as damage to welded wheel tray may occur.
• Canopy should be cleaned regularly and can be cleaned without being removed from the frame. Hose down
and clean with a mild soap and lukewarm water (no more than 100° F.) using a soft bristle brush. Rinse thor
oughly to remove soap. Allow fabric to air dry. TUUCI Parts can be purchased at [email protected]om.
• Do not use a pressure washer to clean canopes.

INSA4000 4.12.17
caution: may cause sudden relaxation
global mission control
2900 NW 35th Street, Miami, FL 33142 USA / 305.634.5116
[email protected]om
europe shade post
Nedervonder 17, 5061 JP Oisterwijk, The Netherlands / +31.13.522.0471
[email protected]
asia shade post
Level 24, 138 Market Street
CapitaGreen, Singapore 048946 / +0650.3794715
[email protected]om
www.tuuci.com
2013 LOGO & COLOR GUIDELINES
FOILS / PMS 1&2 COLOR
GLOSS FOIL
PMS 1795 C
877 DULL FOIL
PMS 1795 C
GLOSS FOIL
877 DULL FOIL
PMS 1&2 COLOR
PMS 877 C
PMS 1795 C
PMS 877 C
PMS 1795 C
BLACK & WHITE 1 COLOR
BLACK
WHITE
INSA4000
04/12/17