TW Audio URA30i User manual

Assembly
Instructions
URA30i

Assembly Instructions URA30i
2
Introduction
The universal rigging adaptor URA30i is an accessory for the T30i loudspeaker.
It is characterized by a subtle look, a remarkable size to weight ratio and ease of use.
Instructions in this user manual
NOTE
TIP
CAUTION
WARNING
Thank you for choosing a high-quality product “MADE IN GERMANY” from the brand
TW AUDiO.
If you lend your product to another party, inform that party of the safety-related operating pro-
cedures and hand over this assembly guide. If you require additional copies of this manual,
you can obtain them free of charge from TWAUDiO or download them from www.twaudio.de
Strictly adhere to the instructions contained in this operating manual that are marked as
follows:
This symbol in combination with the signal word “Warning” identifies a potentially hazardous
situation. Failure to comply with this safety instruction can lead to serious injury or even death.
This symbol in combination with the signal word “Caution” identifies a potentially hazardous
situation. Failure to comply with this safety instruction can lead to light or moderate injury.
This symbol in combination with the signal word “Note” identifies a potentially hazardous
situation. Failure to comply with this safety instruction can lead to product damage.
This symbol in combination with the signal word “Tip” identifies additional information or
notes that will simplify working with TWAUDiO products on the basis of practical experience.

Assembly Instructions URA30i
3
Notes on the products
Read manual
before use!
Before using the device, carefully read the assembly instructions and keep it with the
URA30i universal rigging adaptor.
General information
Assembly instructions: OM-URA30i
Version 2.0 en, 05/2022
© by TWAMBO 2022; all rights reserved.
All information contained in this operating manual was correct to the best of our knowledge
at the time of printing.
Quality warranties or assurance of suitability for a certain type of use based on the technical
specifications, dimensions and weights are not granted by TWAMBO.
TWAMBO also shall not assume liability for any secondary damage (property damage and/or
personal injury) nor for the failure to comply with this operating manual!
TWAMBO reserves the right to update this document based on recent developments.
TWAMBO GmbH
Karl-Hofer-Str. 42
14163 Berlin
Germany
Phone : + 49 (0) 71 41-48 89 89 0
Fax: + 49 (0) 71 41-48 89 89 99
E-Mail: [email protected]
WWW: www.twaudio.de

Assembly Instructions URA30i
4
Content
1. Safety | Intended use...................................................................................................... 5
2. Overview ........................................................................................................................ 7
2.1 Components ........................................................................................................... 7
3. Technical data ................................................................................................................ 8
3.1 Data sheet............................................................................................................... 8
4. Commissioning............................................................................................................... 9
4.1 Setup ...................................................................................................................... 9
4.2 Needed tools for setup ............................................................................................ 9
4.3 Wind load ................................................................................................................ 9
4.4 Assembly URA30i to loudspeaker - upride............................................................. 10
4.5 Assembly URA30i to loudspeaker - cross.............................................................. 11
5. Transport and storage .................................................................................................. 12
6. CE Conformity Declaration............................................................................................ 13
7. Disposal ....................................................................................................................... 13

Assembly Instructions URA30i
5
1. Safety | Intended use
The URA30i universal rigging adaptor was developed for use in professional sound systems.
The universal rigging adaptor may only be used by trained and qualified personnel.
The URA30i universal rigging adaptor may only used with the T30i loudspeaker.
This rigging manual describes how to use the URA30i universal rigging adaptor correctly. Any
other use shall be deemed improper and may result in damage or even injury.
Modifications or alterations to individual parts of the URA30i universal rigging adaptor are not
permitted! Danger to life!
WARNING
Before every operation, check the scope of delivery of the URA30i universal rigging adaptor
for its completeness and ensure that all parts are in perfect condition.
The scope of delivery includes specified components. Only use the recommended and cer-
tified components.
WARNING
The URA30i universal rigging adaptor is designed both for indoor and outdoor use.
CAUTION
The URA30i universal rigging adaptor may only be used by trained and qualified personnel.
Personnel must check the URA30i universal rigging adaptor for suitability before each use.
WARNING
The URA30i universal rigging adaptor must be taken out of operation immediately as soon as
visible damage to the parts can be seen.
WARNING
Please keep all elements of the URA30i universal rigging adaptor away from children! The
small parts can easily be swallowed and lead to suffocation!
WARNING
Please adhere to the following safety instructions to avoid risks when using accessories.
Note the operating modes described in this assembly instructions. Other uses are not per-
missible.
Damage caused by improper use is not covered by TWAMBO.

Assembly Instructions URA30i
6
The payload of the URA30i universal rigging adaptor is designed of one T30i loudspeaker. Do
not exceed this payload.
WARNING
When moving (assembling, dismantling, maintaining) the URA30i universal rigging adaptor
with T30i loudspeaker, ensure sufficient space to prevent collisions with other objects.
WARNING
Do not squeeze or twist the electrical cables of the T30i loudspeaker during the installation of
the URA30i universal rigging adaptor! The respective national electrotechnical rules and regu-
lations are applicable.
CAUTION
Before mounting the URA30i universal rigging adaptor check that e.g. ceilings are capable to
carrying the payload of the components.
WARNING
WARNING
WARNING
Make sure that no water pipes, electrical lines or any other lines are behind the intended place
of mounting.
Only use wall plugs and screws which are suitable for the intended mounting and structural
fabric. All screws must be set and tightened properly. Ensure that the fixing holes have the
correct depth and diameter. Always use all fixing holes.
All screw connections should be checked when the URA30i universal rigging adaptor is
installed. If there are loose screws, tighten them. If this is no longer possible, the screws must
be replaced.
Whenever you make changes to the flown system, always use new cylinder screws (Item1)
as delivered with the product. These items are available from TW AUDiO.
When working with heavy loads exceeding 20 kg (44 lbs.), use suitable aids (dollies, hoisting
slings, etc.). Multiple persons may be required depending on the situation.
NOTE
WARNING
WARNING

Assembly Instructions URA30i
7
2. Overview
2.1 Components
1. Hexagon screw M10 x 20................................................................................ 2 pieces
2. Rigging adaptor URA30i.................................................................................. 1 pieces
Figure 2.1 - Overview
1 2

Assembly Instructions URA30i
8
3. Technical data
Maximum load capacity 1x T30i
Dimensions (h x w x d) 259 x 459 x 40 mm [10.20 x 18.07 x 1,57 in]
Weight 2,3 kg [5.1 lbs]
Surface Powder-coated
3.1 Data sheet

Assembly Instructions URA30i
9
4.1 Setup
The URA30i universal rigging adaptor is designed for hanging operation. TW AUDiO provides
a wide range of accessories to securely attach the swivel bracket.
NOTE
4. Commissioning
4.3 Wind load
WARNING
WARNING
4.2 Needed tools for setup
• Open-end wrench SW17
Have the following tools ready for each setup:
TW AUDiO recommends using only the accessories specified by TWAUDiO for securing and
mounting loudspeakers.
Before setting up the system outdoors, consider unexpected wind conditions at the opera-
tion site!
Disassemble your system immediately when wind speeds exceed 8 bft (34 to 40 kn / 62 to
74 kph / 38.5 to 46 mph) and secure the system components!
Make sure that there are no persons in the immediate vicinity of the system structure!
Make sure that the system structures are not operated over the audience at wind speeds in
excess of 6 bft (22 to 27kn / 39 to 49kph / 24.2 to 30.45mph) and that there are no persons
in the immediate vicinity of the system structure!
Please note that setting up the URA30i universal rigging adaptor always requires two per-
sons!
WARNING
Whenever you make changes to the flown system, always use new cylinder screws (item 1
on scope of delivery) as delivered with the product. These items are available from TW AUDiO.
WARNING

Assembly Instructions URA30i
10
4.4 Assembly URA30i to loudspeaker - upride
Figure 4.4 - Assembly URA30i to T30i loudspeaker - upright
Mount positions 1 and 2 (see figure 2.1) to the T30i loudspeaker as shown in figure 4.4. Be
sure to use both screws.
NOTE
Tighten both screws sufficiently. (torque: 20 Nm)
WARNING
General safety instructions for setting up this rigging variant:
Fasten the URA30i universal rigging adaptor with a shackle and chain hoist according to the
pin points.
Attach this secondary safety component by using a second shackle, chain sling or chain hoist
on another pin point.
For the secondary safety component, the respective national electrotechnical regulations apply.
Use a shackle that is designed according to the payload for each system setup.
WARNING
WARNING
NOTE
WARNING