
Popcorn Popper User Manual
2. The machine must be used together with the suitable power source suggested by the factory,
that power+10%(V).
3. Suitable switch, fuse box and the leak electricity switch should be fixed near the machine,
without piled up rubbish to make it convenient to operate.
4. The ground wire and the power source wire should come from the same place, connected with
a safe three-pin plug in the outlet.
5. All the connection with electricity should be done by the qualified electrician.
E. Operation
1. Turn on the switch of heat preservation to start the heat tube and light.
2. Turn the heating knob to preheat the plate for 5~6 minutes.
3. Put 50ml oil, 150g corn and100g sugar into the plate, and the corn will burst open.
4. Pay attention to the corn while popping in case it will be burnt. Close the door firmly so that the
corn can not come out.
5. Stir the corn until it is all burst open, then pour it out from the plate.
6. Repeat 1~5 to make more popcorn. It needs only 2 minutes to pop the corn continuously.
7. Do not drop any oil around the plate. Otherwise it will catch fire when it is heated to a certain
temperature.
Warning:Do not add any water to the plate while it is popping!
F. Cleanliness and Protection:
1. Cut off the electricity power and pull out the plug to avoid accidents when you clean the
machine.
2. Use the wet towel with some anticorrosive detergent to clean the outside parts of the machine.
Do not clean the machine directly with water. Otherwise the electric function will be damaged.
3. If it is not used for a long time, you should cut off the electricity and pull out the plug.
4. Do not brush the inside part of the plate with hard metal. Otherwise you will damage the coat.
G. Troubleshooting guides:
Appendix to the machine: 1. an operation manual
2. a bulb
e
1 Light not on Not plugged in outlet 1. fasten the screw of
connecting the wires
2. change the light bulb
2 Can not heat 1. loose in wire of the
heated tube
2. heated tube burnt
3. broken electric
capacity
1. fasten the screw from which
the wires come out.
2. change the heated tube.
3. change the electric capacity
3 Too high or
too low
temperature
Broken thermostat Change the thermostat
3
NO.18 - 105, HUAGANG GARDEN, ZHONGSHAN AVENUE, GUANGZHOU, CHINA
T: 86-20-38768241 | F: 86-20-38769376 | WWW.TWOTHOUSANDCO.COM